Ambirad AR13QB SL Handbuch für Installation und Wartung - Seite 20
Blättern Sie online oder laden Sie pdf Handbuch für Installation und Wartung für Gas-Heizung Ambirad AR13QB SL herunter. Ambirad AR13QB SL 20 Seiten. Gas fired radiant tube heaters
Seite drucken
- 1. Table of Contents
- 2. AR and ARE Series Gas Fired
- 3. Gas Connection
- 4. Standards
- 5. Assembly Instructions
- 6. Fitting Reflectors and End Caps
- 7. Burner/Fan/Damper Assembly
- 8. AR and ARE Series Double Linear
- 9. HB and DL Damper Settings
- 9. Installation – Suggested Methods
- 9. Of Heater Suspension
- 10. Flue Connection
- 11. Commissioning for Individually
- 12. Routine Service
- 13. Trouble Shooting Checklist
- 14. User Instructions for Ambi-Rad
19 User instructions for Ambi-Rad AR and ARE series of heaters
Ambi-Rad is an overhead radiant heating system for industrial and commercial buildings. The Ambi-Rad heater is suspended horizontally
overhead from the roof or inclined mounted at 35˚ to 55˚ from the horizontal and heats by radiation in the same way as the sun.
1 This appliance must only be installed by a competent person in accordance with the requirements of the Codes of Practice or the rules in
force.
2 Warning this appliance must be earthed.
3 Never rest anything, especially ladders, against the heater.
To start the Ambi-Rad heater
1 First ensure that the gas supply to the heater is turned on.
2 Ensure that the settings of any time-switch and thermostat are such that the heating system will be required to operate.
3 Switch on electrical supply to heater. Mains light, coloured red will illuminate and ignition sequence will commence.
4 After completion of an air purge period, ignition of the burner will occur and burner light, coloured amber, will illuminate.
5 If lock out occurs, switch off electrical supply, wait 15 seconds then switch on again. If lock-out occurs again switch off heater and call out
a service engineer.
Note Heater will have a tendency to bow when hot, this is quite acceptable.
To switch off Ambi-Rad heater
1 Switch off electrical supply to the heater. The burner will shut off and the fan will stop.
2 If the heater is switched off for periods in excess of one week, it is highly recommended that both gas and electrical supplies are turned
off.
Servicing
To ensure continued efficient and safe operation, it is recommended that the heater is serviced regularly by a competent person,
eg. every year in normal working conditions but in exceptionally dusty or polluted conditions more frequent servicing may be required.
The manufacturer, whose address is given below, offers a maintenance service. Details available on request.
BCEMA
Ambi-Rad Limited Fens Pool Avenue
Brierley Hill West Midlands
5 1
United Kingdom
DY
QA
Telephone 01384 489700
Facsimile 01384 489707
UK sales email sales
ambirad.co.uk
@
Website www.ambirad.co.uk
AMBIRAD is the registered
trademark of Ambi-Rad Limited.
Due to continuous product
innovation, Ambi-Rad reserves
the right to change product
specification without due notice.
Document Reference GB/AR(E)/079/0904
(5000 0904)