ACR Electronics Tenbury TEN1MF Technisches Handbuch - Seite 8

Blättern Sie online oder laden Sie pdf Technisches Handbuch für Herd ACR Electronics Tenbury TEN1MF herunter. ACR Electronics Tenbury TEN1MF 17 Seiten.

Seite drucken

Tenbury insert install manual 1015-3 03/12/2015 09:57 Page 8

Installation of the unit

The appliance is supplied pre-

assembled with the flue spigot in the

top exit position and the Smoke Exempt

stop in place.

The Smoke Exempt stop must not be

removed unless the appliance is

installed in a non-smoke exempt area

and this action should only be

undertaken by a competent person.

To remove the smoke exempt stop,

remove the inner combustion chamber

from the outer convection box, remove

the smoke exempt stop and reassemble

the appliance.

This appliance cannot be installed with

a rear flue option.

Always ensure that the ash draw is fully located before operation of

Using your appliance for the

first time

• To allow the appliance to bed in, and

fixing glues and paint to fully cure,

only fire the appliance using kindling

and just get hot for at least three fires.

• Before lighting the next small fire

please allow the appliance to return

back to room temperature.

• During these first small fires you may

experience a haze and unpleasant

smell as the paint cures, do not touch

the paint and keep the room well

ventilated.

Operating your stove

the appliance

Please note that during the first firing,

we recommend a small fire is lit and

that you slowly increase the

temperature to enable the various

parts to expand normally.

You may also experience fumes and a

haze being given off by the stove during

the first firing and possibly for the next

couple of firings as the paint cures. This

is normal but please ensure that the

room is well ventilated during this

period.

The appliance should not be operated in

mild weather with smokeless fuel. Under

Remove the trim by pulling it towards

the front of the appliance.

Remove the vermiculite baffle by

lifting and rotating through the

combustion chamber.

Remove the 6 x 10mm bolts holding

the flue collar disc in place.

Remove the flue disc and flue collar

through the combustion chamber.

Slide the appliance into the prepared

opening and affix using the predrilled

fixing holes located in the flange.

Connect the flue adaptor and liner to

the flue collar and seal using an

appropriate sealant.

Push the adaptor, liner and free

floating flue collar assembly upwards

and reconnect the flue collar disc in

place with the 6 x 10mm bolts.

Replace baffle and trim.