AMCI SD17060B-03 Benutzerhandbuch - Seite 3
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Servoantriebe AMCI SD17060B-03 herunter. AMCI SD17060B-03 20 Seiten. Stepper drives
Seite drucken
INTRODUCING THE SD17060B
This manual is designed to get you up and running quickly using the SD17060B or
SD17060B-25 stepper drivers. As such, it assumes you have some basic knowl-
edge of stepper systems, such as the resolution you want run your motor at, and
the reasons why you'd want to use Idle Current Reduction and the reasons why
you wouldn't. If these terms or ideas are new to you, we're here to help. AMCI has
a lot of information on our website and we are adding more all the time. If you
can't find what you're looking for at http:///www.amci.com, send us an e-mail or
call us. We're here to back you up with all of our knowledge and experience.
Applicable Units
This manual applies to all SD17060B drivers manufactured after December of 2008 as well as some
SD17060B drivers manufactured during December of 2008. This manual also applies to all SD17060B-03
and SD17060B-25 drivers. You will be able to determine the date of manufacture from the serial number on
the driver. Serial numbers for all AMCI drivers are formed from a date code and sequential number. The
serial number format is shown below.
"D" prefix on all Drive
Month of Manufacture
Year of Manufacture
For SD17060B Drives...
If your year of manufacture is 2009 or later, (digits 3 and 4 are "09" or greater), then this manual
applies.
If your month and year of manufacture is December of 2008, (digits 1 through 4 are "1208"), and the
sequential number is "0135" or greater, then this manual applies.
If your month and year of manufacture is December of 2008, (digits 1 through 4 are "1208"), and the
sequential number is less than "0135" then most of the information in this manual applies. The only
difference is that these older SD17060B drivers require external resistors for input signals greater than
5Vdc. Refer to Appendix A on page 18 for additional information.
If your month and year of manufacture is November of 2008 or earlier, (digits 1 through 4 are "1108"
or less), then most of the information in this manual applies. The only difference is that these older
SD17060B drivers require external resistors for input signals greater than 5Vdc. Refer to Appendix A
on page 18 for additional information.
For SD17060B-03 Drives...
The "-03" option was added in February of 2010. This manual applies to all SD17060B-03 units.
For SD17060B-25 Drives...
SD17060B-25 drivers have different resolution settings than the SD17060B and SD17060B-03. In
addition to this change, the SD17060B-25 will only accept 24Vdc input signals. The SD17060B-25
cannot be used in systems that have 5Vdc differential or 12Vdc single ended signals.
20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786
Tel: (860) 585-1254 Fax: (860) 584-1973 http://www.amci.com
Serial Numbers
Digits 1&2
Digits 3&4
Serial Number of the 135th drive manufactured
in December of 2008.
Digits 5-8
Sequential Number
within the month
3