AMEO POWERBREATHER PB01 Handbuch - Seite 5

Blättern Sie online oder laden Sie pdf Handbuch für Tauchinstrument AMEO POWERBREATHER PB01 herunter. AMEO POWERBREATHER PB01 9 Seiten.

PUTTING IT ON
THIS IS HOW TO PUT ON THE POWERBREATHER PROPERLY
1.
If you swim with goggles, you should always
put them on before the POWERBREATHER.
2.
Open the TWIST LOCK SYSTEM
completely by turning the wheel
counter-clockwise.
TIPS
The POWERBREATHER stays in place
better with a bathing cap. If you swim with
goggles, then always put them on before
the POWERBREATHER.
Does the mouth piece sit comfortably?
If not, it can be moved up or down by slightly
turning the EASY FIT AIR JUNCTION.
Ideally, it should fit without pressure on
the upper and lower jaws.
08
3.
Hold the POWERBREATHER in both
hands like this, so that the AMEO
lettering on the front end of the device
points upward.
4.
Now fold the D-TUBES upward
at the same time, so that they are
positioned at a 90-degree angle
to the mouth piece.
5.
You can now hold the mouth
piece loosely in your mouth
and pull the D-TUBES parallel
over your head. The D-TUBES
should run above the ears
– approximately along the
temples.
Caution: Do not pull the
D-TUBES forcefully apart.
The POWERBREATHER is
currently limited to head
width of approx. 17.5cm
6.
Now fix the POWERBREATHER in
place on the back of the head with the
TWIST LOCK SYSTEM. To do this, turn
the twist lock clockwise until the device
sits comfortably but firmly in place.
09