Ametek Land NIR-2K Installationshandbuch - Seite 5
Blättern Sie online oder laden Sie pdf Installationshandbuch für Laborausrüstung Ametek Land NIR-2K herunter. Ametek Land NIR-2K 20 Seiten.
Seite druckenNIR-656 / NIR-2K
1
This Installation Guide gives instructions on how to the install the AMETEK Land
NIR-656 / NIR-2K Fixed Thermal Imaging System. The system is operated from
IMAGEPro or IMAGEViewer software, both of which are available from AMETEK Land.
These instructions are provided as a series of simple installation diagrams, covering
the installation of the NIR-656 / NIR-2K thermal imaging camera and its mountings,
accessories and services.
The equipment must be used, maintained and serviced by properly trained personnel,
capable of following the procedures given in these instructions. Safety may be impaired
if the system is not used as indicated.
It is important to check the equipment with which you have been supplied and then
read these instructions thoroughly before proceeding with operation.
There are two basic installed configurations covered by this guide.
Control Computer Installation
Imager
PSU Installation
Imager
Installation Guide
Optional
Purge
Blower
IMAGEPro or
IMAGEViewer
Optional
Protection Jacket /
Back Cap / Air Purge
Optional
Water
Cooling
Optional
Purge
Blower
Optional
Protection Jacket /
Back Cap / Air Purge
Optional
Water
Cooling
INTRODUCTION
Optional
Input/Output
Signals
Capable of providing 12 to 30V dc
Max 1% ripple
PSU
Voltage outputs isolated from local ground.
Thermal Imaging Camera
Optional
Remote
Computer
1