AMPLIFIED ENGINEERING fatbox G3 Handbuch - Seite 6
Blättern Sie online oder laden Sie pdf Handbuch für Gateway AMPLIFIED ENGINEERING fatbox G3 herunter. AMPLIFIED ENGINEERING fatbox G3 20 Seiten.
Seite drucken
ABOUT
1.3
BOARD INTERFACE
FRONT PLATE
BACK PLATE
LED:
POWER ON
GENERIC 'YES'
AUTOPING/
IPSEC/ Custom
Program
fatbox G3
amplified
engineering
USB port
Main LAN Port ETH0
(default: 192.168.1.1)
dc
Power
Serial Input Port (4-way plug in terminal)
(Left to Right)
1 – TX output of serial port
2 – RX input of serial port
3 – INPUT, general purpose input port, switch to GND (pin 4) to activate
4 – GND
GENERIC 'NO'
SIGNAL STRENTH LEVEL
AUTOPING/
single:
connection poor
Custom Program
dual:
connection good
signal
cell1
Second LAN Port ETH1
(default: 10.1.1.1)
eth1
eth0
serial
TX RX IN GND
1 2 3 4
D- D+
gps
cell2
DIP Switch
dip
fatbox G3
R
amplified
engineering
System Reset
Press <1 second, soft reset the router
Press >5 seconds, will revert
parameters to Factory Default
fatbox G3
Antenna Port 1
GPS Antenna
Antenna Port 2
This is a 4-way general purpose
switch available to user application
program. DIP #4 (right-most) is
dedicated as 'TEST MODE'
*
which
is activated when DIP #4 is in 'OFF/
down' position during power up.
*
During 'TEST MODE' , after power up is
stable (e.g. 1 minute) a program will
monitor a switch (contact between #3
and #4 of
Serial Input
Port)
Press #1, if INPUT (#3 of
Serial Input
Port) is working,
LED
'YES' will blink
once
Press #2, with a 'loop back' wire
connected between #1(TX) and #2(RX)
of the
Serial Input
Port. The
LED 'YES'
will blink twice
Press #3, once a 3G/GPRS/EDGE session
is established,
LED 'YES'
will blink three
times