Amron AMCOM III 2830A-13 Anweisungen zur Programmierung - Seite 2
Blättern Sie online oder laden Sie pdf Anweisungen zur Programmierung für Kopfhörer Amron AMCOM III 2830A-13 herunter. Amron AMCOM III 2830A-13 3 Seiten. Base station & remote headset
Seite drucken
BASE STATION & REMOTE HEADSET PROGRAMMING
When programming a replacement headset, the base-station needs to be cleared before a "Remote" unit can be linked to it.
Follow the steps below to clear the base-station. All remote units should be "OFF" before starting this process.
1. Remove base-station from the Amron Communicator lid. Channel selection buttons "1" and "2" are located on the rear side
of base-station.
2. Turn Amron Communicator Power "ON". Located on the bottom right of the HUB, turn the base-station dial switch "ON".
The Green LED, located on the left side of base-station next to power jack, will turn on.
3. Press the base-station #1 programming button until the Red LED starts flashing.
4. Press the base-station #1 programming button 7 times. The Red LED will begin rapid flashing, and then will go out. At this
point, the base-station has no remotes programmed to channel 1.
5. Press the base-station #2 programming button until the Red LED starts flashing.
6. Press the base-station #2 programming button 7 times. The Red LED will begin rapid flashing, and then will go out. At this
point, the base-station has no remotes programmed to channel 2.
7. The headsets channels are now cleared of programing to the base-station.
Follow the "Base-Station Programming Instructions" to link headsets.
28B Wireless System Programming
CLEARING THE BASE-STATION
© 2020 - Copyright Amron International, Inc. All Rights Reserved
REV 2.0