Bosch DISHWASHER Betriebsanleitung - Seite 8

Seite drucken

Dishwasher Setup

Water Softening System

Your dishwasher requires soft water to ensure proper washing results

and is equipped with an internal water softening system. However, if

you have a household water softening system, the internal system pro-

vided is not needed.

For the water softening system to function properly, it will need to use

the dishwasher water softening salt. The amount of salt dispensed can

be set from "H:00" to "H:07". Salt is not required at H:00 (this is the

default factory setting). The amount of salt required depends on the

degree of hardness of your tap water. See Table 1.

Open the door and turn the unit on using the [ON/OFF] button.

Hold down the "A" button (see page 4) and press [START] until

the display indicates "H:00".

Release both buttons.

Press the "C" button to select the desired setting.

Save the selected setting by pressing [START] and close the door.

Using the water hardness test strip

Dip the test strip into tap water for a second. Shake

off excess water and wait approximately 1 minute

Salt

Refill the salt container, using a funnel to pour, right before turning on the unit

to ensure that salt overflow is immediately washed away. This prevents corro-

sion. See Figure 1.

Open the screw cap of the salt container.

Fill the container with water (only required when turning on the unit for the

first time).

Add dishwasher salt until the was is displaced and runs out.

Refill with salt as soon as the salt refill indicator is lit.

Warning: Never fill the salt dispenser with detergent. It will destroy the water

softening system. To prevent corrosion, refill with salt and immediately begin any cycle.

Note: Refill salt only when the "Refill Salt" LED or the salt refill symbol is lit (model dependent).

Do not use salt tablets or any salt other than dishwasher water softening salt.

For more information about ordering salt please contact Customer Service.

before comparing results.

After 1 minute

Setting of

the test strip will

internal

show you the

water

correct setting

softener

H:00

H:02

H:04

H:06

Fill water

softener with

salt?

yes

Figure 1