Electrolux DVK5510SW Gebrauchsanweisung - Seite 31
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Lüftungshaube Electrolux DVK5510SW herunter. Electrolux DVK5510SW 36 Seiten.
Auch für Electrolux DVK5510SW: Gebrauchsanweisung (36 seiten)
3.4 - Connecting suction or filter hoods
3.4 - Connecting suction or filter hoods
1 - Connecting suction hoods (air is discharged into the atmosphere)
The hood comes with two air outlets, a plastic cover fitted in the
1 - Connecting suction hoods (air is discharged into the atmosphere)
rear hole and a flange to be fitted according to the solution chosen:
The hood comes with two air outlets, a plastic cover fitted in the
top discharge (fig. 8), rear discharge (fig. 9). In case of installation
rear hole and a flange to be fitted according to the solution chosen:
with rear discharge, fit the plastic cover in the top hole and the
top discharge (fig. 8), rear discharge (fig. 9). In case of installation
flange in the rear hole. Using a pipe Ø 100 o 120 mm, connect the
with rear discharge, fit the plastic cover in the top hole and the
air discharge flange to the external discharge duct. Open the grid
flange in the rear hole. Using a pipe Ø 100 o 120 mm, connect the
panel by pressing inwards on the knobs (fig. 10), check that the lever
air discharge flange to the external discharge duct. Open the grid
(hood with one motor) or the handle (hood with two motors) points
panel by pressing inwards on the knobs (fig. 10), check that the lever
to the ducting mode position (fig. 11), remove the charcoal filter, if
(hood with one motor) or the handle (hood with two motors) points
any, by turning the handle anti-clockwise (see par.3.3 2 part 2°).
to the ducting mode position (fig. 11), remove the charcoal filter, if
Respect warning 2.1
any, by turning the handle anti-clockwise (see par.3.3 2 part 2°).
2 - Connecting filter hoods (air is filtered and recirculated inside the
Respect warning 2.1
room) Open the grid panel, check that the lever (hood with one
2 - Connecting filter hoods (air is filtered and recirculated inside the
motor) or the handle (hood with two motors) points to the filter mode
room) Open the grid panel, check that the lever (hood with one
position (fig. 11), insert the charcoal filter
motor) or the handle (hood with two motors) points to the filter mode
2°).
position (fig. 11), insert the charcoal filter
2°).
3.5 - Electrical connection and working test
3.5 - Electrical connection and working test
1 - The safety measures 2.2, 2.3 and 2.4 of paragraph 2 are to be strictly observed.
2 - Once the electrical connection has been completed, check that the worktop illumination, motor
1 - The safety measures 2.2, 2.3 and 2.4 of paragraph 2 are to be strictly observed.
and speeds work properly.
2 - Once the electrical connection has been completed, check that the worktop illumination, motor
and speeds work properly.
GB
EN
GB
(see par.3.3 2 part
(see par.3.3 2 part
11
11
8
8
9
9
10
10
20
31
20