Bose Lifestyle 35 Series II Installationshandbuch - Seite 36

Blättern Sie online oder laden Sie pdf Installationshandbuch für Kopfhörer Bose Lifestyle 35 Series II herunter. Bose Lifestyle 35 Series II 42 Seiten. Noise cancelling
Auch für Bose Lifestyle 35 Series II: Installationshandbuch (36 seiten), Benutzerhandbuch (25 seiten), Benutzerhandbuch (24 seiten), Benutzerhandbuch (13 seiten), Handbuch zur Schnelleinrichtung (3 seiten), Betriebshandbuch (46 seiten), Benutzerhandbuch (36 seiten), Benutzerhandbuch (32 seiten), Schnellstart-Handbuch (2 seiten), Werksreset (2 seiten), Schnellstart-Handbuch (2 seiten), Benutzerhandbuch (38 seiten)

Seite drucken
Bose Lifestyle 35 Series II Installationshandbuch
O
C
PTIONAL
ONNECTIONS AND

Other jacks on the media center panel

Figure 33
Additional jacks on the
media center rear panel
36
A
DDITIONS
There are other, optional connections you can make as needed.
Antenna extender
IR Emitter
Serial Data

Antenna extender as an option

If your remote control does not communicate with the media center, but the batteries are still
good, you may need extended transmission range. Use an antenna extender, which may be
purchased at an authorized Bose

IR emitter cable as an option

You can set your LIFESTYLE
it or to the media center. An IR signal sent from the media center to the
component makes this additional control possible.
If a component does not respond to the LIFESTYLE
IR (infrared) signals may not be reaching it.
For greater assurance that the IR signals reach the target component while you are setting
the remote to control the component, use the optional IR emitter. After the control is set up,
you may not need to continue using the emitter. Or keep it connected for use with one
component, as needed.
Note: For information on how to set the LIFESTYLE
Operating Guide.
To use the emitter:
1. Insert the 3.5 mm plug at one end of the cable into the IR Emitter jack on the media
center panel.
2. At the other end of the cable, place the rounded surface near the component.
3. Move the emitter around, as necessary, to find the best position.
4. Use the double-sided tape enclosed with the emitter to affix it in position near the
component.
Note: If you have questions, need to obtain a replacement emitter, or want to purchase an
add-on IR emitter (Part Number 277896-001), which can work with up to three components,
contact Bose Customer Service. Refer to the address list included in the carton.

Data port

Some systems will have a data port for future use.

Serial data jack

This jack is for factory and service use only.
Français
Media center connector panel
®
dealer and plugs into the media center.
®
remote to control your TV and other components connected to
®
system remote control commands, the
®
remote to control the TV, refer to your
Español
English
Data port