Alert-it Care Systems P161B Benutzer-/Installateurhandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Benutzer-/Installateurhandbuch für Sicherheitssystem Alert-it Care Systems P161B herunter. Alert-it Care Systems P161B 13 Seiten. Radio door activity monitor

Seite drucken
Location:
Below are some typical mounting arrangements. It will be noted that the magnet can be
angled and lie above the case of the P161, which means it will seldom be necessary to
modify architrave. The unit comes with screws and self-adhesive pads suitable for the
installation. The pads are usually sufficient unless the user is prone to causing damage. The
unit can be fixed to metal doors but this may reduce the range. There MUST be sufficient
clearance to allow the key to be used if required. Mounting horizontal on the door top edge
(d) is a good option which makes the key-hole visible.
a
The units are NOT waterproof (rating IP61 if mounted with keyhole downwards)
and hence must be installed so as to protect from rain. As the unit can be disabled
when the door is open and it self arms on closure this need not pose an issue even
on external doors. The unit should be installed on the outside of bedroom doors so
the staff can access the controls and users cannot cause damage.
Magnet Position
After installation the magnet should lie close to the area marked
"Sense Area" on the P161. The magnet is especially strong and
will influence the switch over a reasonable gap (25mm) and from
top or side, making installation particularly easy

Range Test

It is most important to check that the alarm signal will reach all the places where
the pager will be used. This is easiest achieved by temporarily setting the unit into
Securelink mode (see p
The message NEW! 0187 (or similar) should appear every 10 seconds to show that
the radio link is functioning. A quick press of HELP (less than 1 sec) will also send
a radio transmission and prove communication.
Securelink Mode
In health critical applications it is advisable to use the Safelink radio in secure
mode (see p7). This will shorten the battery life but ensure that any failure of equip-
ment or radio path is reported

Installation

b
7
) and taking the pager to the extremities of the building.
UH1115 P161B Door Activity Handbook.ppp page 3 of 12
c
d