DSC PC3000RK Gebrauchsanweisung - Seite 5

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Sicherheitssystem DSC PC3000RK herunter. DSC PC3000RK 15 Seiten.

Trouble Display

The PC3000 continuously monitors a number of possible trouble conditions. If one

of these conditions occurs, the keypad sounder will beep quickly twice every 10

seconds and the keypad "Trouble" indicator will light. Pressing any key on the

keypad will silence the beeper but the "Trouble" light will remain on until the trouble

condition is cleared. If you cannot determine the cause of the trouble condition, call

your installer for assistance. Press the [

trouble. The zone lights indicate the type of trouble condition.

Zone Light

Press [#] to return to Ready.

NOTE: The keypad buzzer will not sound for AC failure until there is also a low

battery condition. The "Trouble" light will come ON as soon as AC fails and will

remain on until AC restores.

If your system is equipped with smoke detectors or other fire alarm detectors, use

the following instructions for resetting an alarm. Before resetting a fire alarm signal,

be sure you know the source of the alarm and that there is no danger (see

Evacuation Planning elsewhere in this manual).

The system bell/siren alarm signal pulses 2 seconds ON and 2 seconds OFF when

the alarm is generated from the fire circuit. The transmission to the monitoring

station is delayed by 30 seconds. The alarm may be silenced and the transmission

delayed for 2 minutes by pressing any number key on the keypad. If the detector

causing the alarm is reset before the 2 minute delay expires, no further alarm will

occur. If the detector is not reset, at the end of the delay the alarm will start again

and the transmission will occur in 30 seconds if a keypad key is not pressed.

An immediate fire alarm signal and transmission is generated by holding down the

[1] and [3] keys at the same time for 2 seconds.

Some smoke detectors require entering a keypad command to reset them after an

alarm. Press [

cleared, the smoke detector will reset and the fire zone light will go out when the [4]

key is released. If the smoke has not cleared from the detector, open a window or

door and fan clean air into the detector and try resetting again.

Trouble

Defective Stand-by Battery

AC Power Failure (see NOTE below)

Day Zone Trouble

Telephone Line Problem

Unsuccessful Communication Attempt with

Monitoring Station

Bell Circuit Failure

Smoke Detector Circuit Trouble

Loss of Time on System Clock

] then hold down the [4] key for several seconds. If the smoke has

] then [2] keys to display the type of