ANSMANN POWERLINE 5 PRO Handbuch - Seite 5

Blättern Sie online oder laden Sie pdf Handbuch für Beleuchtungsanlagen ANSMANN POWERLINE 5 PRO herunter. ANSMANN POWERLINE 5 PRO 5 Seiten.
Auch für ANSMANN POWERLINE 5 PRO: Handbuch (20 seiten)

Seite drucken

LCD DISPLAY

"- --" is shown when there is no rechargeable battery inserted

but the charger is connected to mains.

"- -- mAh" is shown during the first charging cycle when in "TEST"

mode.

"Full" is shown when the charging process is finished and the

charger switches to trickle charging. After finishing the charging

program "TEST" or "REFRESH", the display switches between "Full"

and the measured discharging capacity in mAh/Ah.

"ERR" and "Lo" are displayed alternately if the rechargeable bat-

tery inserted has an internal short-circuit and so is defective.

"ERR" and "Hi" are displayed alternately if the rechargeable

battery inserted exhibits a very high resistance or a non-rechar-

geable battery is inserted. In all such cases, no charging occurs.

Please remove the defective batteries and dispose of these in an

environmentally friendly manner.

During the charging process the pre-set parameters are display-

ed as mentioned under point 3 (DISPLAY). In addition, the chosen

charging program and the current process (CHARGE or DISCHARGE)

are shown. In the illustration [3] you can see an example of the

LCD display. This example shows 4 different display modes and 4

different charging programs.

CHARGING OF 9V RECHARGEABLE BATTERIES

One 9V battery can be charged, if no D batteries are inserted in

the inner round cell charging slots. When inserting the 9V battery

pay attention to the correct polarity referring to the symbol in

the charging slot. The LED charging indication lights up red when

the battery is inserted correctly. The 9V battery is charged with

a gentle current of ca. 15mA. After approx. 24 hours, the charge

process ends automatically and the LED illuminates green. The

rechargeable battery is charged and will be supplied with the

trickle charge current so long as it remains in the device. If the

indicator flashes red, the battery has an internal short circuit and

should be disposed of.

ENVIRONMENT

Do not dispose of the device in the normal household waste.

Please return it to your dealer, nearest recycling centre or collec-

tion point. Please also recycle all packing materials.

CARE & MAINTENANCE

To make sure that the charger works properly, please keep the

contacts in the charging slots free from dirt and dust. To clean

the unit disconnect it from the mains and only use a dry cloth.

Deutsch |

English

TECHNICAL DATA

Input voltage external power supply: 100-240V AC / 50-60Hz

Input voltage car adapter:

Input voltage charger:

Charging current for round cells:

Charging current for 9V batteries:

Maximum charging capacity:

USB-charging socket:

DISCLAIMER

Information in these operating instructions can be changed

without prior notice. ANSMANN cannot accept liability for direct,

indirect, accidental or other claims by not using this device as

indicated by these operating instructions. Consequential losses

are not accepted at any time.

WARRANTY NOTICE

We hereby offer a 3 year warranty on this charger. This does not

apply to damages caused by: low quality batteries leaking inside

the charger, non-compliance of the operating instruction or

physical damage due to lack of care.

Technical details subject to change without prior notice. No liabi-

lity accepted for typographical errors or omissions. 02/2016

12V DC (Do NOT use with 24V

sockets!)

12V DC

400mA – 1800mA

15mA

11000mAh for round cells

300mAh for 9V block-style

batteries

5V / 1000mA. (Can be used

at the same time as cell

charging).