DSC WLS916-433 Series Installations- und Betriebsanleitung - Seite 4

Blättern Sie online oder laden Sie pdf Installations- und Betriebsanleitung für Rauchmelder DSC WLS916-433 Series herunter. DSC WLS916-433 Series 4 Seiten. Wireless smoke detector

Seite drucken

Specifications

Diameter (base) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5.8in (147mm)

Height (including base) . . . . . . . . . . . . . . . . . . . . . . . . 2.077in (528mm)

Operating Temperature . . . . . . . . . . . . . . . . . . . . 32º-100ºF (0º-37.8ºC)

Humidity . . . . . . . . . . . . . . . . . . . . . . . . . 5%-95% RH, non-condensing

Alarm Sensitivity (threshold) ULC, EU . . . . . . 2.5%±0.5%/ft obscuration

Alarm Sensitivity (threshold) UL . . . . . . . . . . 2.5%±0.5%/ft obscuration

Warning threshold. . . . . . . . . . 75% of alarm threshold for 120 seconds

Heat Alarm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 135ºF (57.2ºC)

Supervisory Transmission Frequency UL, ULC . . . . . . .64 minute intervals

Supervisory Transmission Frequency EU . . . . . . . . . . .12 minute intervals

Sounder Alarm Pattern UL, EU . . . . . . . . . . evacuation temporal pattern

Sounder Alarm Pattern ULC. . . . . . . . . . . . . . . . . . . . . continuous beeps

Operating Temperature . . . . . . . . . . . . . . . . . . . . 32º-100ºF (0º-37.8ºC)

Humidity . . . . . . . . . . . . . . . . . . . . . . . . . 5%-95% RH, non-condensing

Batteries (2) CR123A TekCell

Low Battery Detection

Low battery 14 days remaining

Approved Batteries . . . . . . . . . . . . . . . . . . . . . . . . . . . Duracell DL123A

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Energizer EL123AP

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Panasonic CR123A

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Sanyo CR123A

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Tekcell CR123A

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Varta CR123

Alarm Indications

Condition

LED

Normal

Flash 1/50s

Alarm Smoke

Flash 1/1s

Alarm Heat

Flash 1/1s

Early Warning

Flash 1/50s

Smoke

Compensation

OFF

Trouble High

Compensation

OFF

Trouble Low

Sensor/

OFF

Internal Fault

Low Battery

Flash 1/50s

0 - 7 days

Low Battery

Flash 1/50s

0 - 7 days &

Test or Alarm

Low Battery

Flash 1/50s

After 7 days

Tamper

Flash 1/50s

Sounder Transmission

OFF

Supervisory

Temporal

Alarm

or Steady

Temporal

Alarm

or Steady

CHIRP

None

CHIRP

Trouble

CHIRP

Trouble

CHIRP

Trouble

OFF

Low Battery

CHIRP

Low Battery

CHIRP

Low Battery

OFF

Tamper

Limited Warranty

Digital Security Controls Ltd. warrants that for a period of twelve months from the date of pur-

chase, the product shall be free of defects in materials and workmanship under normal use and

that in fulfillment of any breach of such warranty, Digital Security Controls Ltd. shall, at its

option, repair or replace the defective equipment upon return of the equipment to its repair

depot. This warranty applies only to defects in parts and workmanship and not to damage

incurred in shipping or handling, or damage due to causes beyond the control of Digital Secu-

rity Controls Ltd. such as lightning, excessive voltage, mechanical shock, water damage, or

damage arising out of abuse, alteration or improper application of the equipment.

The foregoing warranty shall apply only to the original buyer, and is and shall be in lieu of any

and all other warranties, whether expressed or implied and of all other obligations or liabilities

on the part of Digital Security Controls Ltd. Digital Security Controls Ltd. neither assumes,

responsibility nor authorizes any other person purporting to act on its behalf to modify or to

change this warranty, nor to assume for it any other warranty or liability concerning this prod-

uct.

In no event shall Digital Security Controls Ltd. be liable for any direct, indirect or consequen-

tial damages, loss of anticipated profits, loss of time or any other losses incurred by the buyer

in connection with the purchase, installation or operation or failure of this product.

Smoke Detectors

Smoke detectors that are a part of this system may not properly alert occupants of a fire for a

number of reasons, some of which follow. The smoke detectors may have been improperly

installed or positioned. Smoke may not be able to reach the smoke detectors, such as when the

fire is in a chimney, walls or roofs, or on the other side of closed doors. Smoke detectors may

not detect smoke from fires on another level of the residence or building.

Every fire is different in the amount of smoke produced and the rate of burning. Smoke detec-

tors cannot sense all types of fires equally well. Smoke detectors may not provide timely warn-

ing of fires caused by carelessness or safety hazards such as smoking in bed, violent

explosions, escaping gas, improper storage of flammable materials, overloaded electrical cir-

cuits, children playing with matches or arson.

Even if the smoke detector operates as intended, there may be circumstances when there is

insufficient warning to allow all occupants to escape in time to avoid injury or death.

Warning: Digital Security Controls Ltd. recommends that the entire system be completely

tested on a regular basis. However, despite frequent testing, and due to, but not limited to,

criminal tampering or electrical disruption, it is possible for this product to fail to perform as

expected.

Important Information: Changes or modifications not expressly approved by Digital Secu-

rity Controls Ltd. could void the user's authority to operate this equipment.

FCC Compliance Statement

CAUTION: Changes or modifications not expressly approved by DSC could void your

authority to use this equipment.

This equipment generates and uses radio frequency energy and if not installed and used prop-

erly, in strict accordance with the manufacturer's instructions, may cause interference to radio

and television reception. It has been type tested and found to comply with the limits for Class

B device in accordance with the specifications in Subpart "B" of Part 15 of FCC Rules, which

are designed to provide reasonable protection against such interference in any residential

installation. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause interference to television or radio reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

• Re-orient the receiving antenna

• Relocate the alarm control with respect to the receiver

• Move the alarm control away from the receiver

• Connect the alarm control into a different outlet so that alarm control and receiver are on dif-

ferent circuits.

If necessary, the user should consult the dealer or an experienced radio/television technician

for additional suggestions. The user may find the following booklet prepared by the FCC help-

ful: "How to Identify and Resolve Radio/Television Interference Problems". This booklet is

available from the U.S. Government Printing Office, Washington, D.C. 20402, Stock # 004-

000-00345-4.

Industry Canada Compliance Statement

This Class B digital apparatus meets all requirements of the Canadian interference-causing

equipment regulations.

Cet appareil numérique de la Classe B respecte toutes les exigences de règlement sur le maté-

riel brouilleur du Canada.

IC:160A - WLS916NB

" The term "IC:" before the radio certification number only signifies that Industry Canada tech-

nical specifications were met."