Anzzi SD-AZ11-01 Series Handbuch für Installation und Betrieb - Seite 10

Blättern Sie online oder laden Sie pdf Handbuch für Installation und Betrieb für Sanitärprodukt Anzzi SD-AZ11-01 Series herunter. Anzzi SD-AZ11-01 Series 16 Seiten. Glass shower door

Anzzi SD-AZ11-01 Series Handbuch für Installation und Betrieb
2
This shower door must be mounted to a stud. Minimum threshold space is required.
IMPORTANT: Using a stud finder, ensure the wall intended to hold the door has a stud
at the installation point. A stud in this location must be identified to mountthe support
bar in order to proceed with the installation. If there is no stud in the shown area, we
recommend employing a qualified contractor to install one. (Fig 2.1)
1.
Carefully remove the Corner Protector from the bottom corner of Fixed Panel [01] and
place Fixed Panel [01] on to the deck of bath tub. (Fig 2.2)
Note: Make sure to clean the deck before placing Fixed Panel [01] on it.
2.
Gentlypush the Fixed Panel [01] to the wall. Use a levelto make sure it's plumb and level.
(Fig 2.2)
3.
Adjust and push the Glass Supports [03] to the wall. Use pencil to mark the screw hole
location forAnchor on the wall. (Fig 2.2)
4.
Install the Gasket and Anchor 2 of Fixed Panel Bottom Clip [11] to the Fixed Panel [01]
as the figure shows. Mark the outline of the Anchor 2 on the deck. (Fig 2.2)
5.
Remove the Fixed Panel [01] and install the Corner Protector back to the bottom corner
of it. Gentlyplace it on the floor on acloth or blanket.
8
2