Audiovox 1181286 Einbauanleitung - Seite 3

Blättern Sie online oder laden Sie pdf Einbauanleitung für Car Video System Audiovox 1181286 herunter. Audiovox 1181286 4 Seiten. Ford explorer overhead console for use with flipdown video system

Seite drucken

FIGURE 1

3. Install console mounting bracket (item 2 pg 2)

over O.E. bracket on roof brace. Secure rear of

bracket using (2) two O.E. screws. Secure front

of bracket using (2) two #8 x 3/4" screws (item

1 pg 2) See Figure 2.

INSTALLATION INSTRUCTION # 44-0026B

I. PREPARATION OF VEHICLE INTERIOR

1. Carefully trim headliner as shown.

Caution: Before cutting headliner material,

check for wiring or other componentry

above headliner. Cut only where indicated.

Make sure that the 8 1/2" cut is centered left to

right in vehicle.

2. Remove and retain (2) two O.E. screws which

secures O.E. bracket to roof brace. See Fig. 1.

FIGURE 2

II. PREPARATION OF CONSOLE

FOR INSTALLATION

4. Install the video system in console (item 3 pg 2)

and secure using hardware supplied with video

system. Start all screws before tightening. Begin

with the rear center screw, then alternately tighten

screws around the perimeter of pod. See Figure 3.

Refer to owner's manual supplied with video

system. Caution: Do not overtighten screws.

See Figure 1.

July 7, 1999

Printed in the U.S.A.