Apogee 00524 Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Handbuch für Spielzeug Apogee 00524 herunter. Apogee 00524 10 Seiten. Fin shape science experiment kit

Seite drucken

12. Locate the plywood centering ring

without any notches on it. Using wood glue,

attach it to the inside of one end of a red

coupler.

13. Apply wood glue to the threads of

the metal screw eye, and screw it into the

plywood bulkhead. Do not twist it in past the

threads on the shank. Apply glue to both

sides of the bulkhead where it exits the hole.

14. Glue the bulkhead into the remaining

red tube coupler using wood glue. Recess

it slightly into the end of the tube. When the

glue has dried, put a fillet of glue on both

sides of the bulkhead where it touches the

inside of the tube.

15. Take the engine mount tube from

step 11. Put a bead of wood glue around

the outer perimeter of the plywood ring and

a ring of glue just forward of the cut-out as

shown. Slide the red coupler from step 12

over the rear end of the engine mount tube

so the coupler is even with the front end of

the plywood centering ring. Wipe off any

excess glue that oozes out onto the surface

of the coupler, and allow the glue to dry.

16. Take the metal engine hook and put

the tab on the front into the slot at the rear

end of the cutout on the engine mount tube

as shown. Locate the plywood centering ring

with the wide notch on the inner circle. Slide

the notch over the engine hook and glue the

ring between the etched lines on the engine

mount tube. Put a fillet of glue on both sides

of the ring where it touches the tube.

17. Glue the two launch lugs onto the 9

inch long tube inside the rectangles that are

etched into the surface of the tube. Make

sure the lugs are aligned straight so they will

slide easily on the launch rod. Apply a fillet

of glue to both sides of the lugs and allow

them to dry.

Page 4

Notch for

Slot

engine hook

Etched

lines