Apogee Atomizer 05054 Schnellstart-Handbuch - Seite 6
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Spielzeug Apogee Atomizer 05054 herunter. Apogee Atomizer 05054 8 Seiten.
Seite drucken
Display Stand Assembly
Display Stand Assembly
Remove the display stand pieces from the laser-cut
sheet. Assemble the leg pieces together. Run a thin
bead of wood glue along all the joints between the
pieces. When the glue is dry, the stand can be painted
and a rocket can be placed on it.
Launch Supplies Needed
Launch Supplies Needed
To launch your rocket you will need the following:
● A model rocket launch pad with a 1/8-inch (3.175mm)
launch rod and launch controller
● Rocket Recovery Wadding
● Several recommended 18mm Rocket Engines for the
Atomizer are listed in the motor chart.*
*Go to our website for a broader motor selection for this
kit at
https://www.apogeerockets.com/Model-Rocket-
Kits/Skill-Level-2-Model-Rocket-Kits/Atomizer#motors
Rocket Preflight
Rocket Preflight
A. Fold the parachute as shown.
B. Crumple and insert 2 or 3 sheets of recovery
wadding into the tube with a dowel. Slide the folded
parachute into the tube behind the recovery wadding.
Then slide the nose cone into the main body tube.
Page 6
*Atomizer Suggested Motor Chart
*Atomizer Suggested Motor Chart
Manufac-
Engine
turer(s)
Loaded
Estes
A8-3
Estes
B4-4
Quest
C18-4
Quest
D20-4
Aerotech
D13-5
Step A
Step B
Est. Altitude
Motor Type
Ft
Single Use
92
Single Use
204
Single Use
390
Single Use
487
Single Use
650
m
28.0
62.2
118.9
148.4
198.1