Apollo REACH WIRELESS RW1300-110APO Schnellstart-Handbuch - Seite 2
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Schiffsausrüstung Apollo REACH WIRELESS RW1300-110APO herunter. Apollo REACH WIRELESS RW1300-110APO 4 Seiten. Sounder base
Seite drucken
Status LED
The REACH Wireless Sounder Base includes a 360° LED
indicator which to indicate status conditions. See table 1.
Table 1: REACH Wireless Device Status & LED
Indication
Device Status
Tamper Not
Power Up
Power Up (dip-switch ON)
Blinks alternatively green/red four
Entering Wake-Up
Link Success
Enters wake-up mode and signals
Link Failure
'Entering wake-up mode' following
Normal Condition
Activation
Battery Faults
Tamper Fault
Replaced
Tone & Volume Selection DIP Switch Settings
Device Addressing
Device addressing is handled by the REACH Wireless Loop-
Interface device (RW1700-030APO).
Devices are soft-addressed automatically when pairing with
the Loop Interface and can be changed manually. Hard-
addressing using Apollo XPERT cards are not supported.
Table 2: REACH Wireless DIP Switch Functionality
DIP Switch
DIP Switch Group Function
Number
1
2
3
Tone Selection
4
5
6
Volume Selection
7
8
High/Low Power LED Output
LED Indication
Tamper
Activated
Activated
Blinks green four times
Blinks red four times
times
Blinks green four times, then
repeats
this failure
LED off
LED off
LED off
Red on
Amber blinking
LED off
every 5s
LED off
Blinks amber two times
Notes
Check Tone Table
(Table 6)
Check Volume
Table (Table 3)
N/A
Table 3: REACH Wireless Volume Table
Volume
High*
Medium High
Medium Low
Low
*EN54-3 certified, for Tone Table (Table 6), see appendix
Communication
REACH Wireless Devices use 'radio-frequency' wireless
communication to connect to the Loop-Interface.
The Loop-Interface (RW1700-030APO) translates the wireless
communication into wired Apollo protocol communication,
with each device addressable individually by the fire panel.
See datasheets for the Loop-Interface for more information.
Base Compatibility
This device is compatible with the following detector products
(see table 4). It can also be used standalone with a blanking
cap (see table 5).
Table 4: REACH Wireless Detector Compatibility
Part Number
RW1000-400APO
RW1000-600APO
RW1000-700APO
Table 5: REACH Wireless Blanking Cap Compatibility
Part Number
RW1300-010
REACH Wireless AV Base Cap - White
RW1300-020
REACH Wireless AV Base Cap - Red
Maintenance and Service
Maintenance must be performed in accordance with all
applicable standards. Clean the detector externally using a
soft damp cloth. For full cleaning and recalibration detectors
should be returned to Apollo Fire Detectors.
Batteries
REACH Wireless devices are supplied with two CR123 bat-
teries, battery A and B. The device switches periodically
between the two batteries on a controlled sequence. For cor-
rect operation of the device, both batteries are required with
adequate capacity reserves.
When battery A reaches a low power threshold, it will trig-
PP5103/2022/Issue 1
Page 2 of 4
DIP Configuration
11
01
10
00
Product Name
REACH Wireless Heat Detector
REACH Wireless Optical Smoke
Detector
REACH Wireless Multisensor
Optical/Heat Detector
Product Name