Apollo Sprayers MAXI-MISER PBC7600-GTO Gebrauchsanweisung - Seite 9

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Farbspritzgerät Apollo Sprayers MAXI-MISER PBC7600-GTO herunter. Apollo Sprayers MAXI-MISER PBC7600-GTO 20 Seiten.

Seite drucken

1. Remember to always keep the distance between the spray gun and the surface the same when moving across your work,

(or up and down) called a "pass". Do not rotate or turn your wrist from side to side. See Chart C below.

2. Move the spray gun across your work from end to end.

3. Be sure to maintain the same speed of movement. This ensures an even application of coating.

4. At the end of a "pass" always release the trigger. To continue, spray in the opposite direction and overlap your previous

coat by 1/3 to 1/2.

5. When finished you should have an even wet coat on your work. If you have dry spots, you have overlapped too wide. If you

have heavy or wet spots, you have overlapped too much or moved the spray gun too slowly.

6. When spraying an entire car, start at the top and work down.

7. Try to spray the hard to reach and underneath surfaces first.

Common sense and some forethought will prevent errors. Remember, that a light wet film will generally produce better results

than a heavy wet coat. When spraying a vertical surface, it is advisable to apply a thin/light "tack" coat first, followed by a

normal light wet coat. This technique will help prevent "runs" and "sags".

Chart C

When using your Spray Gun you control five variables:

1. Fluid flow.

2. Distance of the spray gun from your work. 4"-8" (10-20cm) is ideal. Closer if necessary.

3. Pattern direction (vertical fan, horizontal fan and round).

4. Speed of application.

5. Fan pattern width.

NOTE: Items 1, 2, and 4 directly relate to each other.

6.2

Cleaning Your PBC7600-GTO Spray Gun

After you have finished spraying, follow these simple steps to clean your PBC7600-GTO spray gun:

6.2.1 Partial Cleaning

Cleaning your PBC7600-GTO spray gun does not have to be a difficult task. Often, when spraying a variety of clear coatings,

a thorough rinsing and wiping of basic parts is all that may be necessary. The basic steps below are for simple and easy

cleaning of your PBC7600-GTO spray gun.

1. Empty any unused material (paint) from the cup and wash out any residue with an appropriate cleaner compatible with

the coating, or water if using water-based material. Partially fill the cup with cleaner and spray through the gun to flush

out the material passages.

Spray Gun Technique