Datamax I-Class Mark II Handbuch für Installation und Gebrauch - Seite 9

Blättern Sie online oder laden Sie pdf Handbuch für Installation und Gebrauch für Drucker-Zubehör Datamax I-Class Mark II herunter. Datamax I-Class Mark II 12 Seiten. General purpose input output (gpio) option
Auch für Datamax I-Class Mark II: Schnellstart-Handbuch (4 seiten)

Seite drucken

Failure to properly configure the GPIO Port can result in damage to the printer and / or connected devices.

WARNING

Signal

Direction

Name

Ground

N/A

+5 VDC

[2]

Start Of Print

Slew Label

Input

Toggle / Pause

Reprint

+24 VDC

N/A

Ground

Ribbon Low

Service Required

End Of Print

Media Out

Output

Ribbon Out

Data Ready

Option Fault

[1]

Signal directions given relative to the printer.

[2]

If active with no current print job, "WAITING FOR DATA" will be displayed. Specifying a quantity of 9999 while keeping this signal ON will cause non-stop label printing, except

in single label "Imaging Mode", which will cause the printer to stop between labels. See the Operator's Manual for details.

[3]

For details see PRINTER OPTIONS / GPIO PORT in the Operator's Manual.

GPI/O Port A Jumper Overview

[1]

Jumper

Position

Installed

JMP 3

Removed

Installed

JMP 2

Removed

N/A

When inactive, outputs will be

pulled up to a voltage

determined by this jumper

setting, where:



Pins 1 – 2 = +5VDC;

JMP 1



Pins 2 – 3 = +24VDC; or,



None = an external voltage

(not to exceed +30VDC) via

external pull-ups providing a

20K ohm feedback path

through any two outputs.

Function / Description

Printer chassis is used.

Ground must be supplied.

Printer +5VDC is used (.5 amp maximum)



Note: Drawing more than .5 amps can cause unreliable printer operation.

+5VDC must be supplied.

[3]

Programmable

Media is advanced until the signal goes HIGH and, if not in continuous mode, the label

is positioned at the next available TOF.

The printer pauses when the signal is taken LOW.

The last label is reprinted exactly, with no increment or time stamp changes;

recommended for use during error conditions. Keeping this signal LOW produces non-

stop printing.

Printer +24 VDC (1.5 amp maximum).

Printer chassis.

Programmable

[1]

. Signifies a RIBBON LOW DIAMETER warning condition.

Evoked by occurrences listed under 'Fault Messages.'

[1]

Programmable

. Signifies the End of Print (EOP) process.

Evoked during an Out of Stock condition. Active LOW.

Evoked during an Out of Ribbon condition. Active LOW.

Evoked when a label is waiting to print. After Start of Print is received, printing will begin.

For synchronization with the print cycle, End Of Print indicates the completion of the

process. Active LOW.

Evoked during a Linear Scanner or RFID fault condition. Active LOW.

[1]

Active LOW.