ADE M501020 Betriebshandbuch - Seite 4
Blättern Sie online oder laden Sie pdf Betriebshandbuch für Skalen ADE M501020 herunter. ADE M501020 20 Seiten. Electronic wheelchair scales
Seite drucken
Mains and battery connection for the scales
Power is supplied either through the rechargeable battery pre-installed in the display unit or through
mains power via the supplied power unit. The imprinted voltage value must match the voltage on-site.
Connect the mains cable to the connection socket and connect the mains plug to a wall socket. Note:
The wall socket must be located near to the unit and be easily accessible. Only the power adapter
supplied may be used. The connection socket for the mains cable must be securely connected to the
display unit.
The power unit supplied is simultaneously used to charge the battery pack.
When charging the battery for the first time, ensure a sufficient charging period of approx. 24 hours.
If you are using the unit in battery mode and the display indicates – Lo, then the battery must be re-
charged by plugging in the power adapter.
Allow a charging period of 12-16 hours. The battery must be charged with the unit switched off. When
the battery is fully charged and the unit switched on, –Lo- must not appear on the display. If it does,
please inform your service partner.
Mains connection
The following diagram shows the pin ar-
rangement for mains connection:
Installing a rechargeable battery
The battery compartment is located on the front of the unit.
1) Open the battery compartment.
2) Remove the battery cables carefully from the housing, connect the wires (red to red, black to
black) and insert the battery into the housing.
3) Close the battery compartment again.
Only use original rechargeable batteries and charger units. The warranty does not cov-
er any damage caused by using other types of batteries or charger units.
Tips for handling the batteries
The life of a battery depends essentially on the load, frequency of use, temperatures, settings and the
accessories used.
New batteries or batteries that have been stored for long periods require a longer charge peri-
od.
Charge the batteries at room temperature.
Store the batteries empty (uncharged) in a cool, dark and dry place.
Never subject the batteries to temperatures below -10°C (14°F) or above 45°C (113°F).
Over the course of time, batteries lose their charge capacity and require a longer charge peri-
od. If the battery performance drops considerably, then it is time to replace the battery.
New batteries are supplied partially charged. Some batteries only achieve their full capacity af-
ter several complete charge and discharge cycles.
When disposing of disused batteries, observe the valid legal and municipal regulations.
Never dispose of batteries in fire as they can leak or explode!
4
Pin
1
Name
DC+
2
3
DC-
Mass
M501020-210322-Rev006-UM-e