ADE PFA6000 Betriebshandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Skalen ADE PFA6000 herunter. ADE PFA6000 15 Seiten. Electronic precision scale

ADE PFA6000 Betriebshandbuch

Adjust the scale

Take the scale and the equipment carefully out of the carton and check it for completeness.
Adjust the scale in this way that all four feet have contact with the footprint, which should be safe
and even.
Check the horizontal stand of the scale by the help of the bubble level which is insert (seen
from the operator side) on the backside of housing.
At correct adjustment, the bubble must be in the centre of the circle.
In case of an uneven stand, you can balance the level by the help of the four levelling feet. For this
purpose, rotate the relevant foot out of the housing more in or out.
Before first time use place the stainless steel weighing platform on the weighing plate and if
necessary adjust the draft shield on the scale in that way that all four corners are outside of the
rubber mounts and find one's feet.
For protection against outside influences during the weighing procedures, place the cover on the
draft shield frame.

Assembling of wind shield

The wind shield is only applicable for round weighing platforms.
(Model PFA1000)
1. Remove packaging and protection fims before assembling.
2. Insert four shores to the frame
as the arrow shown. Please see
the order alternation of notch (Pic 1).
3. Insert 4 side sheets into frame and
and shores ordinally (Pic 2).
4. A second frame has to be mounted
on the top of the four side sheets (Pic 3)
5. Insert handle and top sheet then place
them on the top of the frame as the
arrow shows (Pic 4).
The scale can be used with or without windshield.
PFA-200702-Rev004-UM-en
Pic. 1
Pic. 2
Pic.. 4
Notch
Pic. 3
4