ADEMCO 4110XM Installationsanleitung Handbuch - Seite 9
Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Sicherheitssystem ADEMCO 4110XM herunter. ADEMCO 4110XM 20 Seiten.
• Use the House ID Sniffer mode to select a House ID that is not being used in a nearby system
as follows:
a. Enter the [Master Code] + [#] +[2].
While in this mode, the keypad will display the House ID transmitted by any wireless
devices in the area. It may take some time for all wireless devices in the area to send a
signal, so it is recommended that you leave the system in this mode for approximately 2
hours. If any House ID numbers are displayed, select another number for this system.
IMPORTANT
b. Exit this mode by entering the [Master Code] + [1] OFF.
5. Install Sounding Devices
U L
6. Install the Remote Keyswitch
IMPORTANT
7. Connect the Telephone Line
IMPORTANT
8. Connect the AC Transformer
• Use the wiring table at the end of this section for maximum wire lengths per gauge.
WARNING
9. Connect the Battery
IMPORTANT
U L
10. Connect Earth Ground
• Connect Terminal 21 to a good earth ground (Metal Cold Water Pipe, or AC Power Outlet
Ground from a 3 prong, 120VAC outlet. This is necessary for the lightning protection
devices in this control to work properly.
Remove all batteries from transmitters before going into the House ID
Sniffer Mode.
Use only UL Listed sounding devices for UL installations.
When using a keyswitch, the system cannot support wireless.
Make sure telephones on the premises are connected only through the
alarm control panel (disconnect from the incoming phone line at the
telephone jack). This is necessary to have true line seizure.
DO NOT PLUG THE TRANSFORMER INTO THE AC OUTLET UNTIL
ALL OTHER WIRING TO THE CONTROL IS COMPLETE.
Do not attach the connector cable to the battery's terminals until
after you have plugged the AC transformer into an uninterrupted
120VAC outlet.
1. In UL installations, maximum current draw from the Auxiliary
Output and the Alarm Output combined must not exceed 600mA.
2. Use a 3A battery or larger for UL installations.
-9-