ADEMCO 5805-4 Einbauanleitung - Seite 2

Blättern Sie online oder laden Sie pdf Einbauanleitung für Transmitter ADEMCO 5805-4 herunter. ADEMCO 5805-4 2 Seiten. Wireless key transmitter

REPLACING THE BATTERY

FOR WARRANTY INFORMATION AND FOR DETAILS REGARDING THE LIMITATIONS OF THE

ENTIRE ALARM SYSTEM, REFER TO THE INSTALLATION INSTRUCTIONS FOR THE

RECEIVER/CONTROL WITH WHICH THIS DEVICE IS USED.

THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING

TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE

MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE

UNDESIRED OPERATION.

165 Eileen Way, Syosset, New York 11791

Remove case back by using the blade of

a small screwdriver to pry it open.

Remove old battery

Place batter in case back locations (see

diagram above). - NEGATIVE END

MUST FACE DOWN.

To close, snap case front and back

together.

Important Note: Do not remove Printed

Circuit Board.

SPECIFICATIONS

Unit Dimensions:

55mm x 37mm x 12.7mm

Battery:

Maxell CR2032, Duracell DL 2032, or Varta

CR2032

FCC ID: CFS8DL5805