Autonet In-Car Router Installationshandbuch - Seite 2

Blättern Sie online oder laden Sie pdf Installationshandbuch für Automobilelektronik Autonet In-Car Router herunter. Autonet In-Car Router 4 Seiten. In-car router

Seite drucken

Safety Precautions

The Autonet Mobile installation instructions must be followed to minimize

potential interference with other electronics on the vehicle.

WARNING

To prevent injury or fire, take the

following precautions:

• When extending the ignition, battery, or

ground wires, make sure to use auto-

motive grade wires or other wires with a

diameter of Xmm (AWG 16) or more to

prevent wire deterioration and damage to

the wire coating.

• To prevent a short circuit, never put or

leave any metallic objects (such as coins or

metal tools) inside the unit.

• If the unit starts to emit smoke or

strange smells, disconnect immediately and

consult the Autonet Mobile Customer

Service Center.

• Do not touch the In-Car Router during

use because the surface of the unit be-

comes hot and may cause burns if touched.

• Mounting and wiring this product re-

quires skills and experience. For safety's

sake, leave the mounting and wiring work

to professionals.

CAUTION

To prevent damage to the In-Car Router,

take the following precautions:

• Be sure the In-Car Router is connected

to a 12v DC power supply with a negative

ground connection.

• Do not open the bottom covers of the

In-Car Router.

• Do not install the In-Car Router in a spot

exposed to direct sunlight or excessive heat

or humidity. Also avoid places with too much

dust or the possibility of water splashing.

• When replacing a fuse, only use a new

one with the prescribed rating. Using a

fuse with the wrong rating may cause your

unit to malfunction.

• To prevent a short circuit when replacing

a fuse, first disconnect the wiring harness.

NOTE

• If you experience problems during instal-

lation, consult the Autonet Mobile Cus-

tomer Service Center.

• If the In-Car Router does not seem to be

working right, consult the Autonet Mobile

Customer Service Center.

Wiring

• Take the power wire for the In-Car

Router directly from the ignition power

source. If it's connected to the vehicles

wiring harness, it can cause blown fuses,

etc. If it is connected directly to the cars

battery it can deplete the battery.

• Do not allow the wire to directly contact

the edge of the iron plate by using grom-

mets.

• Connect the ground wire to a metal part

of the car chassis that acts as an electrical

ground passing electricity to the battery's

negative terminal. Do not turn the power

on if the ground wire is not connected.

• Be sure to install the protective fuse in

the power cord.

• For the power cord and ground, use a

vehicle type (fireproof) power wiring cord

with a current capacity greater then the

units fuse capacity. Use a power cord with

a diameter 8mm (AWG 8) or greater.

Cleaning the In-Car Router

If the In-Car Router becomes dirty, turn

off the power and wipe the panel with a

dry silicone cloth or soft cloth.

Do not wipe the In-Car Router with a hard

cloth or a cloth dampened by volatile sol-

vents such as paint thinner and alcohol.

They can scratch the surface of the In-Car

Router and/or cause the sealant to peel off.

To prevent the battery from draining

please refrain from leaving the key in the

ACC on position. This powers the In-Car

Router up and could possibly deplete the

battery.