Hifonics TITAN TD200R Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Handbuch für Subwoofer Hifonics TITAN TD200R herunter. Hifonics TITAN TD200R 8 Seiten. Dual bassreflex subwoofer systems

Seite drucken

ENGLISH

POWER RATING

The HiFONICS TITAN TS subwoofer enclosures are designed for high bass levels. Anyhow it is

possible, that unsatisfying sound characteristics could be caused by too low or too high amplifier

power. In certain circumstances this even can cause a damage to the loudspeakers.

It is recommended to choose rather a more powerful amplifier (ca. 15-20% more Watts RMS than

the max. RMS power rating of the woofer) and to use the amplifier not at the maximum output level

(low distortion factor, good sound characteristics). A weaker amplifier at the maximum level causes

worse sound characteristics due to the higher distortion factor.

Never crank up the output volume of your amplifier to the maximum level or run the amplifier into

the clipping range. If the sound is distorted and not clean, turn back the level until the distortions

disappear.

The HiFONICS TITAN TS subwoofer enclosures have no integrated limiter or clipper, which is limit-

ing the level upwards. Overamplified bass peaks leads inevitably to a burn out of the voice coil of

the woofer. A burn out of the voice coil, caused by clipping/overamping is not covered by the usual

warranty.

IMPORTANT NOTES

Choose a suitable location for your sound system, that neither the driver's field of vision nor the

security of the inmates will be affected. This stands also for airbag-zones and safety belts. The per-

manent temperature of the location should not be lower than 5°C and not higher than 50°C. Protect

the device from moisture and humidity.

Ensure that your subwoofer enclosure will not get loose during the drive and hurt someone in the

passenger cabin. It is recommended, that you mount the subwoofer enclosure with suitable belts or

any other mounting solutions in the trunk area.

Please observe not to damage any serial components of your vehicle (air bags, wires, gas tank etc.)

during the installation of your sound system by drilling or any other operations.

Never screw or mount any other devices (amps, caps etc.) onto the subwoofer enclosure, this may

cause damage to the electricity.

For your personal concerns you should choose a appropriate sound level for the subwoofer enclo-

sure, that neither the roadworthy of the driver nor his concentration will be disturbed, that he is able

to notice possible traffic noises and acoustical warning signals.

Modern car audio sound systems provide very high acoustic pressure beyond the 100 dB mark.

Please observe in this case, that permanent use of high sound levels may cause damage to your

ability of hearing.

Please ensure by any means the correct polarity of all connections. Faulty installed and connected

devices may get damage the vehicle and the device permanently.

Please check in any case the operation guide or wiring manual of your amplifier which you'd like to

use for the sound system.

Never connect the speaker terminals with the 12 Volt power supply, otherwise the speakers may

get damaged.