909 TCAT235 Gebrauchsanweisung - Seite 7
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Säge 909 TCAT235 herunter. 909 TCAT235 17 Seiten.
Seite druckentheir own weight. Supports must be placed under the
panel on both sides, near the line of cut and near the
edge of the panel.
e. Do not use dull or damaged blades.
or improperly set blades produce narrow kerf causing
excessive friction, blade binding and kickback.
f. Blade depth and bevel adjusting locking levers
must be tight and secure before making cut.
adjustment shifts while cutting, it may cause binding and
kickback.
g. Use extra caution when making a "plunge cut" into
existing walls or other blind areas.
blade may cut objects that can cause kickback.
The protruding blade may cut objects that can
cause kickback.
a. Check lower guard for proper closing before each
use.
Do not operate the saw if lower guard does not
move freely and close instantly. Never clamp or tie the
lower guard into the open position. If saw is accidentally
dropped, lower guard may be bent. Raise the lower guard
with the retracting handle and make sure it moves freely
and does not touch the blade or any other part, in all
angles and depths of cut.
b. Check the operation of the lower guard spring.
guard and the spring are not operating properly, they
must be serviced before use. Lower guard may operate
sluggishly due to damaged parts, gummy deposits, or a
build-up of debris.
c. Lower guard should be retracted manually only for
special cuts such as "plunge cuts" and "compound
cuts."
Raise lower guard by retracting handle and as
soon as blade enters the material, the lower guard must
be released. For all other sawing, the lower guard should
operate automatically.
d. Always observe that the lower guard is covering the
blade before placing saw down on bench or floor.
An unprotected, coasting blade will cause the saw to
walk backwards, cutting whatever is in its path. Be aware
e. Do not use abrasive wheels
Unsharpened
WARNING.
device with a residual current rating of 30mA or less.
Wear goggles
Wear earmuffs
If blade
Wear a breathing mask
Accessories
The 909 TIMBERCAT TCAT235 Circular saw is supplied
The protruding
with the following accessories as standard:
1. 235 mm (9 1/4") TCT Blade (not fitted)
2. Blade Wrench
3. Parallel Fence
The 909 TIMBERCAT LS1200 Circular saw is supplied
with the following accessories:
1. 165 mm (6 1/2") TCT Blade (fitted)
2. Allen Key
3. Parallel Fence
If the
Unpacking
Due to modern mass production techniques, it is unlikely
that your 909 Power Tool is faulty or that a part is missing.
If you find anything wrong, do not operate the tool until the
parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
Assembly
The 909 circular saw is packed fully assembled, except for
the blade and the Parallel Fence which will need to
be attached.
7
of the time it takes for the blade to stop after switch is
released.
We recommend the use of a residual current