aireRyder F0051 Schnellstart-Handbuch - Seite 7

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Fan aireRyder F0051 herunter. aireRyder F0051 9 Seiten. Original ceiling fan

Seite drucken

Fig.14

Stud

Glass Shade

Attach the glass shade to the glass

holder by aligning studs and slots,

and then turn it clockwise until it is

locked in place.

Dip Switch

1 2 3 4

Frequency Code

Fig.16

Setp 2: Slide code switches on back of remote control.

Step 3: Turn the power on and within 60 seconds, press and hold "SET" button nearby switches. The setup is completed

after the light of the ceiling fan flashes twice.

3. "D" and "ON" dip switch:

The "ON" selection is the light dimmable selection. The "D" selection is the light on only (no dimming function).

Note:The receiver provides protection in the following two situations:

1- Lock protection:The receiver has a built-in protection against obstruction during operation. The motor will be locked and the

power will be disconnected after 30 seconds of obstruction. Please remove obstacles before restarting. To reset, turn off the

power supply to the fan motor, then restart.

2- Power surge protection: If the receiver detects a power consumption of the motor greater than 80W, the power supply will

be interrupted and operation will immediately stop. To reset, turn off the power supply to the fan motor, then restart (after 5

seconds).

3- This remote control has memory function setting. The fan will operate at the same speed and the fan light will stay at the

same brightness as the last time the power supply was turned off.

Glass

Holder

Slot

Remote control

Install one 12 volt battery (type 23AE, included) to the remote control.

1. The remote buttons instruct as below:

● Fan speed:

I = minimum speed

III = medium low speed

V = medium high speed

● ■ Button:

This button turns the fan off.

●

Reverse button:

SET

This button is to control fan direction.

12V

●

Light button:

The button is to control light, Infinite light levels are available by holding the light

on/off button.

2. Frequency Interference (code setting):

Step 1: Turn the power off to your ceiling fan.

Fig.15

II = low speed

IV = medium speed

VI = high speed

PAGE: 7 / 9

Turn ON the electric circuit at the

main fuse or circuit breaker box.

171120