Maisi Smart Dashcam Schnellstart-Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Dash Cameras Maisi Smart Dashcam herunter. Maisi Smart Dashcam 16 Seiten.

vehicle. Once the vehicle engine is started, the camcorder automatically

turns on.

Car charger input: DC 12 / 24V.

Note:

1. Use the product with the supplier charger only, please do not use other

power chargers to avoid camera burn or cause the battery explosion.

2. When use this camcorder for the first time, please charging to battery full.

3. Please note that if the ambient temperature reaches 45° C or above, the

car adapter may supply power to camcorder, but it will not charge the

Lithium-ion.

3 To Use the Device as a Video Recorder

To access the Video menus, if the device powers on and is not automatically

in Video mode, press MODE to the right of the screen until you are in Video

mode (This

icon will show up on the top left corner of the screen) then

press

(on top of the camera) for Setup.

Note: If camera is in Video Mode and it is recording (the red dot

blinking

on top left corner), press REC to stop the recording first, and then press

to go to Menu. (Refer to Note on Page 3)

Resolution

After selecting the Resolution option, navigate among the list using

and

buttons (located to the left of the screen). Select the desired resolution

from the list: 1080FHD, 720P, WVGA, VGA and press REC to confirm.

Loop Recording

Loop recording will allow continuous recording, as the camera records

continuously over the previous footage and overwrites itself. You may set

Loop recording to 2 Minutes, 3 Minutes or 5 Minutes.

Wide Dynamic Range (WDR)

Allowing the camera to use WDR technology automatically to adjust lighting

features to enhance clarity and reduce glare. To access WDR settings, select

the WDR option from the Menu and navigate using the

and

buttons to

select On or Off. Press REC to confirm.

Power On/Off Delay (Available for Some Models Only)

Page 5