IKEA GENOMKYLD Anleitung Handbuch - Seite 12

Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Kühlschrank IKEA GENOMKYLD herunter. IKEA GENOMKYLD 20 Seiten. French door

Seite drucken

DAILY USE

Use of turnover beam

Please keep strictly to the warnings on the

label of the turnover beam. It is a normal

phenomenon that the surface of the turnover

beam is hot. Dews on the surface are also

normal in summer or when the surrounding

environment is wet. What you need to do is

to clean them away with cloth.

Tips: The interior temperature may require a

certain period of time to reach balance if the

setting temperature is changed or other food

is put into the refrigerator. Such a period of

time depends on the change to the setting

temperature, the surrounding temperature,

opening frequency, the amount of the stored

food and etc.

Big drawer

Pull out and install the big drawer:

1. Pull out the big drawer.

2. Find the hook at the left and right sides

at the drawer bottom (shown in the

figure).

3. Hold the hook at two sides with a nose

pliers or tweezers and push it up and out

of the groove of sliding rail (A), and take

out the hook at the other side with the

same method.

4. Take out the drawer.

5. Install the drawer by putting the hook

into the right place.

Note: The big drawer has a maximum load

of 10kg.

Cantilever rack

The cantilever rack could be adjusted to the

proper height as required by food. Please

adjust the cantilever rack by following the

arrows as shown in the diagram. Raise it

upward first and then take it out by tilting it

upward. During installation, put the upper

end of the fixed leg into one of the upper

slots on the supporting iron first and then

put the lower end of the fixed leg into the

third slot on the lower part of the supporting

iron.

Door-mounted bottle rack

Remove the door-mounted bottle rack by

first lifting it straight up: