Airflow Uno hab Installations- und Betriebsanleitung - Seite 8

Blättern Sie online oder laden Sie pdf Installations- und Betriebsanleitung für Heizungsanlage Airflow Uno hab herunter. Airflow Uno hab 16 Seiten. Cavity wall decentralised mechanical ventilation with heat recovery unit
Auch für Airflow Uno hab: Anweisungen (2 seiten), Installation Kit (16 seiten), Wartungshandbuch (2 seiten)

CHAPTER 5
WALL

INSTALLATION

m
WARNING
m ATTENTION!
„Waterproof cover" of the
stainless steel external grille
The stainless steel external
grille is a visual part and does not
serve as Waterproof cover. The
installation of wall installation
sleeve through the outer
facade has to be carried out
on site Waterproof by
appropriate measures!
m
CAUTION
© Airflow - we reserve the right to make changes without prior notice
All of the following information and instructions are intended solely for
authorised electricians!
5.0
Installation
Leave the delivery set in the packaging until installation in order to prevent any possible damage and contamination.
during transport and on site .
m
WARNING!
The following must be observed before all installation work or before opening the terminal compartment:
Isolate the device from the mains power supply and secure against being switched on again!
Installation preparation
– Wall sleeve and external grille/outdoor panel
Before installing the unit Unohab, the wall installation sleeve and the grille outer panel must be mounted (see fig.3) .
Furthermore, the concealed cable routing and all building or renovation measures in the installation space must be
completed.
For this purpose, the Airflow installation and operating instructions for installation kit (Part no.80000776) must be
observed!
Concealed
cable routing
to the
controller
Installation step 1:
– Unit Unohab
Insert the fan unit up to the stop in the wall installation sleeve (fig.4/5).
In this connection, pay attention to the marking on the half shell "TOP" (fig.4).
m
CAUTION!
When inserting the fan unit, do not press on the protection guard (fig.5)!
Fan unit
"TOP"
Installation step 2:
Connect control cable to fan unit connector. In this connection, proceed as follows:
1. Measure and cut cable to length for connection to the fan unit (fig.6)
Distance = edge of wall installation sleeve to fan unit.
2 . For the electrical connection, pull the fan unit out to the edge of the wall installation sleeve with the pull-out tool (fig.7).
Cable length:
Distance = edge
of wall installation
sleeve to fan unit
Cable
Unohab Unit
Wall installation sleeve
fig.4
Lip seal
fig.6
8
Installation and Operating Instructions
External grille
"Stop"
Fan unit
Pull-out tool
2-part
connector
fig.3
fig.5
fig.7