Makita 197413-5 Gebrauchsanweisung - Seite 10

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Bohrer Makita 197413-5 herunter. Makita 197413-5 13 Seiten. Cordless cutter
Auch für Makita 197413-5: Gebrauchsanweisung (13 seiten), Gebrauchsanweisung (12 seiten)

Seite drucken

Drilling operation

First, turn the adjusting ring so that the arrow points to

the

marking. Then proceed as follows.

Drilling in wood

When drilling in wood, the best results are obtained

with wood drills equipped with a guide screw. The guide

screw makes drilling easier by pulling the drill bit into

the workpiece.

Drilling in metal

To prevent the drill bit from slipping when starting a

hole, make an indentation with a center-punch and

hammer at the point to be drilled. Place the point of the

drill bit in the indentation and start drilling.

Use a cutting lubricant when drilling metals. The excep-

tions are iron and brass which should be drilled dry.

CAUTION:

Pressing excessively on the tool

will not speed up the drilling. In fact, this excessive

pressure will only serve to damage the tip of your drill

bit, decrease the tool performance and shorten the

service life of the tool.

CAUTION:

Hold the tool firmly and exert care

when the drill bit begins to break through the

workpiece. There is a tremendous force exerted on

the tool/drill bit at the time of hole break through.

CAUTION:

A stuck drill bit can be removed

simply by setting the reversing switch to reverse

rotation in order to back out. However, the tool

may back out abruptly if you do not hold it firmly.

CAUTION:

Always secure workpieces in a

vise or similar hold-down device.

CAUTION:

If the tool is operated continuously

until the battery cartridge has discharged, allow

the tool to rest for 15 minutes before proceeding

with a fresh battery.

Using the tool as a hand screwdriver

Switch off the tool.

Move the reversing switch lever to the neutral position.

Turn the action mode changing ring so that the arrow

points to the

marking.

Turn the tool.

NOTE: This use is convenient for checking the

screwdriving.

NOTE: Do not use the tool for work requiring exces-

sive force, such as tightening bolt or removing rusted

screws.

Using holster

Optional accessory

CAUTION:

When using the holster, remove a

driver bit/drill bit from the tool.

CAUTION:

Turn off the tool and wait until it

comes to a complete stop before placing it in the

holster.

Be sure to close the holster securely with the

holster button so that it holds the tool firmly.

Thread a waist belt or similar through holster

holder.

► 1 . Holster holder 2. Waist belt

Put the tool in the holster and lock it with the hol-

ster button.

10 ENGLISH