Align-Pilates Combo Chair II Montageanleitung & Benutzerhandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Montageanleitung & Benutzerhandbuch für Fitnessgeräte Align-Pilates Combo Chair II herunter. Align-Pilates Combo Chair II 12 Seiten.

13) Insert the 2 x Jump Board fasteners (29) into place. Then, attach the 2 x Short eyelet bolts (37)
in the 2 holes in the front of the Base Frame with Wheels (6) in a vertical position, as shown in Fig.
15.
14) To assemble the two-part handles slide the 2 x Black Upper Handles (16) over the 2 x Chrome
Height Adjustment Bars for Handles (17) and secure with 6 x Short bolts with loctite & washers (45).
Tighten fully.
15) Slide the assembled handles into the handle holders, 1 on each side, then insert the 2 x Twist
& pull height adjustment knobs (28). To adjust: pull out the Twist & Pull knob, move the handle to
the correct height, let go of the knob to allow the locking pin to locate in to one of the 9 holes.
Once located at the desired height, tighten the knob to prevent rattle and to fully secure the
handles.
16) Finally, before first use go over the Combo Chair II and ensure that all bolts have been
properly tightened then your Align-Pilates Combo Chair II is complete!
8
Fig.14
Fig.13
2 x Small eyelet bolts
with washers & nuts (37)