Alirac HE115-125/950 Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Schleifer Alirac HE115-125/950 herunter. Alirac HE115-125/950 10 Seiten.

Seite drucken
To stop the tool, release the switch
trigger to freely. (Fig5)
Maintenance and Daily care
CAUTION:
Always be sure that the tool is switch
off and unplugging before attempting to
perform inspection and maintenance.
1.The tool and its air vents have to be
kept clean, regularly clean the tool's air
vents or whenever the vents start to become
obstructed.
2.Usually check the all screws if
loosened or not.
3.Usually check the cord insulation if
broken or not.
CAUTION:
Be sure to reinstall the knob after
inserting new carbon brushes.
After replacing brushes, plug in the tool
and break in brushes by running tools with
no load for about 10 minutes. Then check
the tool while running, when releasing the
switch trigger. If the tool is not working well
ask your local MAKUTE service center for
repair.
To
maintain
and RELIABILITY, repairs, any other
maintenance or adjustment should be
performed
by
MAKUTE
or Factory service centers, always using
MAKUTE replacement parts.
Effective and safe operation for Grinding
and sanding
Always hold the tool firmly with one
hand on housing and the other on the side
handle, turn the tool on and then apply the
wheel or disc to the workpiece.
1.The users can get satisfied effects if the
users give 1/2 strength compared with the
own weight of the tool. Over strength is easy
product
SAFETY
Authorized
to make the tool engine an abrasive wheel
damaged because of overload.
2.Generally speaking, please keep the
grinding and cutting part of the wheel and
disc in the scope of 15 to 30 degree with the
surface of processing object. (Fig 6)
3.In general operation, you should start
first then work. In reverse you should leave
workpiece then stop.
Replacing carbon brushes
1.Remove and check the carbon brushes
regularly. Replace when the tool occurs
obvious sparks or wear down to the limit
mark.
2.Both carbon brushes should be
replaced at the same time.
3.Use a screwdriver to remove the
handle cover and take out the worn carbon
brushes, insert the new ones and secure the
brush holder assembly.
-5-
www.makute.com
Fig6