Garmin Colorado 400c Benutzerhandbuch - Seite 11

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Schiffsausrüstung Garmin Colorado 400c herunter. Garmin Colorado 400c 40 Seiten. Oregon series
Auch für Garmin Colorado 400c: Benutzerhandbuch (48 seiten), Kurzreferenz-Handbuch (2 seiten), Schnellstart-Handbuch (2 seiten), Benutzerhandbuch (48 seiten), Wichtige Sicherheitsinformationen (48 seiten), Benutzerhandbuch (26 seiten), (Dänisch) Handbuch (48 seiten)

Mounting the Transducer on a Trolling Motor

(Dual Beam Transducers Only)

To mount the transducer on a trolling motor:

1. Slide the large cable tie through the slot on the transducer

mount with the ridges of the band facing up until equal

lengths extend on both sides of the mount.

NOtE: For cold water, or heavy timber or debris areas, a metal

4-5" worm gear clamp is recommended.

2. Position the mount gasket on the curved top of the

transducer mount.

3. Place the transducer assembly against the motor body of the

trolling motor, with the front of the transducer pointed away

from the trolling motor propeller.

4. Wrap the two ends of the cable tie around the motor body.

Place the pointed end of the cable tie through the fastener

hole on the opposite end and pull it through until it is snug but

not tight. (The cable tie clicks when you pull it.)

5. Position the transducer so that it is parallel with the bottom

when in use, and make sure the gasket is aligned properly.

Pull the cable tie end until tight. Trim off the excess if

necessary. Tighten the 10-32 locking nut until it touches the

mounting bracket, and then tighten 1/4 turn more. (Do not

overtighten.)

Fishfinder 400C Owner's Manual

6. Route the 30-foot (9 m) transducer cable using the supplied

cable ties to secure the cable to the motor shaft. You can fill

the forward-facing portion (except the cable tie pocket) of the

transducer mount with sealant to avoid accumulating debris.

Cable tie

Front of the transducer

400c

nstallIng the

IshFInder