Brother MFC-J6955DW Handbuch zur Produktsicherheit - Seite 18

Blättern Sie online oder laden Sie pdf Handbuch zur Produktsicherheit für Alles in einem Drucker Brother MFC-J6955DW herunter. Brother MFC-J6955DW 23 Seiten.
Auch für Brother MFC-J6955DW: Handbuch zur Schnelleinrichtung (2 seiten), Handbuch zur Produktsicherheit (23 seiten), Handbuch zur Schnelleinrichtung (2 seiten)

comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment to an outlet on a circuit different from that to which the receiver is

connected.

• Consult with an experienced radio/TV technician for help.

• (Wireless network models only)

This transmitter must not be co-located or operated in conjunction with any other antenna or

transmitter.

IMPORTANT

• Changes or modifications not expressly approved by Brother Industries, Ltd. could void the

user's authority to operate the equipment.

• A shielded interface cable should be used to ensure compliance with the limits for a Class B

digital device.

Compliance with FCC requirement 15.407(c)

Data transmission is always initiated by software, which is the passed down through the MAC,

through the digitaland analog baseband, and finally to the RF chip. Several special packets are

initiated by the MAC. These are the only ways the digital baseband portion will turn on the RF

transmitter, which it then turns off at the end of the packet. Therefore, the transmitter will be on

only while one of the aforementioned packets is being transmitted. In other words, this device

automatically discontinue transmission in case of either absence of information to transmit or

operational failure.

Frequency Tolerance: ±20ppm

RF Exposure Notice (USA or Canada Only) (Wireless Models

Only)

This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled

environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the

IC radio frequency (RF) Exposure rules. This equipment should be installed and operated

keeping the radiator at least 20 cm or more away from a person's body.