Indesit SIXL125SEU Handbuch für Service-Informationen - Seite 22
Blättern Sie online oder laden Sie pdf Handbuch für Service-Informationen für Waschmaschine Indesit SIXL125SEU herunter. Indesit SIXL125SEU 28 Seiten. Moon washing machines
Seite drucken
Indesit
Company
Fault indication LEDs flash together with programme button LEDs
FAULT
CAUSE
F01
Motor triac short circuit
LED 1
ON
F02
Motor jammed, motor tacho
generator open or short
LED 2
circuit.
ON
F03
NTC wash thermistor open /
short circuit or wash heating
element relay contacts
LEDs
sticking (signalled at time of
1 & 2
full tub).
ON
F04
Pressure switch stuck on
empty.
LED 3
ON
F05
Machine will not empty or
pressure switch stuck in full
LEDs
position.
1 & 3
ON
F07
Heater relay stuck or element
LEDs
open circuit.
1, 2 &
3 ON
Service Manual UK
CORRECTIVE ACTIONS
-
Check for continuity of motor (Field coil pins 3-5 and
armature pins 1-2);
-
Check efficiency of module connector block J9, motor
terminal block and wiring between motor and edge
connector J9;
-
Check motor not seized;
-
Check edge connector J9 has secure connections on
module;
-
Remove edge connector J9 on module check wiring and
contacts at position 1 and 2 on connector J9;
-
Check tacho generator windings and that there is an
impedance value of between 115 and 170 Ω on the wiring
connector J9 between pins 1 and 2;
-
Check edge connector J8 has secure connections on
module;
-
Check thermistor and wiring;
-
Remove edge connector J8 from module check wiring at
position 11 and 12 on connector J8;
-
Remove plug from thermistor. The resistance at room
temperature (20°C) is approximately 20KΩ.
-
Machine continually fills until it reaches overfill safety level.
Drain pump is then started by overflow contacts in pressure
switch;
-
Check edge connector J3 has secure connections on
module;
-
Check pressure switch connections;
-
Check wiring connections are secure between pressure
switch and edge connector J3 on module;
-
Check pump is not jammed or faulty;
-
Check edge connector J9 has secure connections on
module and drain pump;
-
This fault is only signalled when pressure switch is in the
empty position;
-
Check edge connector J3 has secure connections on
module;
-
Check wiring to heater and continuity of wash element
(25Ω);
-
Check pressure switch connections and correct pressure
switch operation;
22 of 28
English