Indesit DFP 58T94 Betriebsanleitung - Seite 13

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Geschirrspüler Indesit DFP 58T94 herunter. Indesit DFP 58T94 16 Seiten.
Auch für Indesit DFP 58T94: Betriebsanleitung (32 seiten)

Seite drucken

Special wash cycles

and Options

Notes:

Optimum performance levels when using the "Sixty" and

"Rapid" cycles can be achieved by respecting the specified

number of place settings.

To reduce consumption even further, only run the dishwasher

when it is full.

Note for Test Laboratories: for information on comparative

EN testing conditions, please send an email to the following

address: [email protected]

Wash options*

The OPTIONS may only be set, changed or reset after the

wash cycle has been selected and before the Start/Pause

button has been pressed.

Only the options which are compatible with the type of wash

cycle set may be selected. If an option is not compatible

with the selected wash cycle

corresponding symbol flashes rapidly 3 times.

If an option is selected which is not compatible with another

(previously selected) option, it will flash 3 times and switch

off, while the most recently selected option will remain active.

To deselect an option which has been set by mistake, press

the corresponding button again.

Delayed start option

It is possible to delay the start time of the wash cycle

by 3, 6 or 9 hours:

1:After selecting the desired wash cycle and any other

options, press the DELAYED START button. the indicator

light will go on.

2: Select the desired delay time by pressing the Delayed

Start button repeatedly. The wash phase (3 hours), drying

phase (6 hours) and end (9 hours) indicator lights will go on

in succession.

If the Delayed Start button is pressed again, the option is

deselected and the indicator light goes off.

3. After the selection process, the countdown will begin if

the Start/Pause button is pressed. The selected delay-period

indicator light flashes and the Start/Pause button stops

flashing (fixed light).

3. Once this time has elapsed, the DELAYED START indicator

light goes off and the wash cycle begins.

The Delayed Start function cannot be set once a wash

cycle has started.

(see Table of wash cycles)

, the

Half Load

If there are not many dishes to be washed, a half

load cycle may be used in order to save water,

electricity and detergent. Select the wash cycle and press

the HALF LOAD button; the indicator light will go on.

Press the HALF LOAD button again to deselect this option.

The amount of detergent can be halved.

Only available in selected models.