Indesit IT50E1 Betriebsanleitung - Seite 14

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Herde Indesit IT50E1 herunter. Indesit IT50E1 20 Seiten. 50cm free standing electric cooker

Seite drucken

Care and Cleaning

Electric sealed hotplates

The cleaning of sealed hotplates should be done when

they are cold, using a soap filled Brillo pad, following

the grain of the hotplate. This will ensure that any

stubborn, burnt on spillages are removed. Wipe over

with a damp clean cloth, making sure that all the

cleaner has been removed.

Finally, turn on hotplate to warm for a few minutes,

then smear with a little cooking oil to provide a

protective coating, or the restorative agent Homecare

Four Hob, available from our spares department or

leading supermarkets. The bezels will mellow with use

to a burnished gold colour, a soap filled Brillo pad will

help to keep them bright, care should be taken not to

damage the vitreous enamel hob surface.

Note: We do not recommend the use of decorative

covers over the hot hotplates as these can hold

condensation and cause corrosion. Accidental

operation with a cover in place can cause intense

heat. Never place saucepan lids on the hotplates, as

this may cause corrosion.

Grill

Remove the grill pan and the wire grid food support, it

is best to wash these items immediately after use to

prevent stains from being burnt on when used again.

Wipe out the Grill compartment, use a fine steel wool

soap pad to remove stubborn stains from the grill

runners and the floor of the compartment. Wipe over

the control panel with a damp cloth and polish with a

dry cloth.

Control Panel

Do not use cream cleaners, oven cleaners or

aerosols, scouring pads or abrasive powder for

cleaning the plastic knobs as damage will occur.

Decorative Trims

It is advisable to clean the decorative trims regularly to

prevent any build up of soiling. The recommended

method of cleaning is to wipe over the trims with a soft

cloth wrung out in warm water or mild non-abrasive

cleaner. (If in doubt try the cleaner on a small area of

trim which is not noticeable in normal use). Then, after

wiping with a cloth wrung out in clear water, dry with a

soft clean cloth.

Doors

Wipe over the outer door glass panels with a cloth

wrung out in warm soapy water, then after wiping with

a cloth wrung out in clear water, dry with a soft clean

cloth. Ensure that glass doors are not subjected to

any sharp mechanical blows.

Glass Inner Door Panel (where fitted) – open the

door fully and unscrew the two screws securing the

glass panel, taking care not to allow the glass to fall.

The glass panel may now be washed at the sink.

Stubborn stains can be removed by using a fine steel

wool soap pad. Ensure the glass panel is not

subjected to any sharp mechanical blows. Take

particular care not to damage the inner surface which

is coated with a heat reflective layer. After cleaning,

rinse and dry with a soft cloth. For slight soiling the

inner glass panel may be cleaned, while still warm,

without removing it from the door.

Warning: Oven must not be operated with inner

door glass removed.

Take care during cleaning not to damage or distort

the door seals. Do not lift the door seal from the oven

chassis, if necessary remove the seal by carefully

unhooking the corner clips.

Take care that the rating label edges are not lifted

during cleaning, and furthermore that the lettering is

not blurred or removed.

Ovens

Remove the rod shelves and grill pan. Use a fine steel

wool soap pad to remove stubborn stains from the rod

shelves, grill pan and the floor of the oven.

Oven Shelf Supports

The shelf supports are removable and dishwasher

safe.

To remove hold the support at the front and pull away

from the oven side, this can then be cleaned in a sink

or a dishwasher. When removed it allows access to

the oven side, which can be cleaned with warm soapy

water.

To refit the support, insert the longer leg into the rear

fixing hole and push in the front leg.

Oven Lamp Replacement

Open the oven door and remove the rod shelves.

Using a suitable cloth to protect the fingers grip the

light glass dome, unscrew anti-clockwise and lift.

Reach into the aperture with fingers, and unscrew the

lamp anticlockwise. Fit replacement lamp (25W

300°C rated SES), refit dome.

WARNING: To avoid electric shocks - please

ensure that the electricity supply to the appliance

is switched off and the appliance is fully cold,

before removing the lamp lens.