Indesit KD341GW Handbuch für Installation und Gebrauch - Seite 14
Blättern Sie online oder laden Sie pdf Handbuch für Installation und Gebrauch für Herde Indesit KD341GW herunter. Indesit KD341GW 24 Seiten. 50cm gas cooker
Care and Cleaning
Clean the cooker regularly and wipe up spills soon after they occur to prevent
them from becoming burnt on.
TURN OFF THE MAIN SWITCH AND ENSURE THE COOKER IS COLD BEFORE CLEANING.
BEFORE SWITCHING ON AGAIN, ENSURE THAT ALL CONTROLS ARE IN THE OFF POSITION.
NEVER USE BIOLOGICAL WASHING POWDER, CAUSTIC CLEANERS, HARSH ABRASIVES,
SCOURING PADS, STEAM CLEANERS, AEROSOL CLEANERS OR OVEN CHEMICAL CLEANERS
To move the cooker forward, open the grill door and with both hands positioned
under the roof of the compartment, lift and pull forward.
Replace by pushing the cooker backwards. Check that the cooker is level.
Take care to ensure that any floor covering is not damaged.
Do not attempt to lift the product using the grill door or grill door handle.
OVEN SHELF SUPPORTS
The shelf supports are removable and dishwasher safe.
To remove hold the support at the front and pull away from the oven side, this can
then be cleaned in a sink or a dishwasher.
When removed it allows access to the oven side, which can be cleaned with warm
soapy water.
To refit the support, insert the longer leg into the rear fixing hole and push in the front
leg.
OVEN DOOR / GRILL DOOR
Wipe over the door outer panel with a cloth wrung out in hot soapy water, then after
wiping with a cloth wrung out in clear water, dry with a soft clean cloth.
Take care during cleaning not to damage or distort the Door Seal. Do not lift the Door
Seal from the Oven Front Frame, if necessary remove the seal by carefully unhooking
the corner clips.
Do not use scouring pads or abrasive powder which may scratch the surface.
REPLACING THE BATTERY
The battery is not covered by the guarantee. Use an alkaline AA battery. The battery
holder is located in the plinth panel below the oven door. Open the oven door fully.
Press the tag on the left hand side of the battery holder/cover and withdraw it just
enough to get access to the battery.
Fit the new battery with the end marked "+" on the same side of the battery holder as
the red lead. Replace the battery holder by pushing it firmly into the hole in the plinth.
14
OF ANY KIND.