AEG LAVATHERM 59880 Benutzerhandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Trockner AEG LAVATHERM 59880 herunter. AEG LAVATHERM 59880 32 Seiten. Aeg tumble dryer

Changing door stop

WARNING!

Before changing the door stop, disconnect the mains plug.

Open loading door.

Unscrew hinge A from the front of the

appliance and take off the loading door.

Remove cover plates B. To do this, insert

a thin screwdriver into the slots as

shown in the illustration, push down-

wards slightly and pry out the cover

plates.

Use an appropriate tool and exert pressure to unfasten locking block C from the snap-

on fixture, take out and re-insert on the other side having rotated the block through

180°.

Unscrew hinge A from the loading door, rotate through 180°, re-insert on the opposite

side and screw down.

Re-insert cover plates Bon the opposite site having first rotated them through 180°.

Unscrew cover plates D from the front

of the appliance, rotate through 180°,

screw on the opposite side.

Unscrew door lock E, push down slightly

and remove from the front of the appli-

ance.

Push snap-in button F in and down,

push cover down slightly and remove from front of the appliance.

10. Change door lock E over to the opposite side, screw down the door interlock.

11. On the other side, insert cover F and allow snap-in button to lock into place.

12. Insert loading door and hinges into recesses on the front of the appliance and screw

down.

Note regarding contact protection: The appliance is only secure for operations again

once all plastic parts have been inserted.

• Stacking kit

These intermediate installation kits can be used to arrange the dryer and a washing ma-

chine (60 cm wide, front loaded) as a space-saving washer/dryer stack. The washing ma-

chine is at the bottom and the dryer is at the top.

Read carefully the instructions supplied with the kit.

Available from your Service Force Centre or your specialist dealer

• Draining kit

Installation kit for direct draining of the condensed water into a basin, siphon, gully, etc.

The water reservoir then no longer has to be drained, it must however remain in its in-

tended position in the machine.

Installation