Aqua Creek Products F-702RLNA-SPA-02 Handbuch - Seite 10

Blättern Sie online oder laden Sie pdf Handbuch für Hebesysteme Aqua Creek Products F-702RLNA-SPA-02 herunter. Aqua Creek Products F-702RLNA-SPA-02 18 Seiten. Revolution spa lift

Pull-out Legrest Installation Instructions
The PULL-OUT LEGREST ASSEMBLY is designed to fit under the standard Aqua Creek chair, and is installed
inside the 2" square tubing that supports the chair from underneath. Installation is the same for every lift,
Ranger lift is shown in picture below. To install the pull-out leg-rest;
1. With a flat-blade screwdriver, pry off the 2" square plug from the end of the 2" square tube of the seat arm.
SEE FIGURE 8.
2. Drill a 9/32" hole at the location indicated in FIGURE 9 through the bottom of the chair support tube. Drill
only through the bottom of the tube. Remove the burrs from the hole before installing the legrest assembly.
10
Copyright © 2018 Aqua Creek Products All Rights Reserved
2" SQUARE
PLUG
DRILL
9/32" HOLE
(BOTTOM OF CHAIR SUPPORT TUBE)
(SEE DRAWING TO THE RIGHT)
SEAT
SEAT ARM
FIGURE 8
DRILL
9/32"
(THIS SIDE)
CHAIR SUPPORT TUBE
(BOTTOM VIEW)
FIGURE 9
3/4"
1"
Revised 11/30/18