Deye INGE Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Inverter Deye INGE herunter. Deye INGE 20 Seiten. Hybrid inverter

Current transformer (Optional)

Battery sensor

L-type Hexagon wrench

Chart 3-1 Parts List

3.2 Mounting instructions

Installation Precaution

This Hybrid inverter is designed for outdoor use(IP65),Please make sure the installation

site meets below conditions:

・ Not in direct sunlight

・ Not in areas where highly flammable materials are stored.

・ Not in potential explosive areas.

・ Not in the cool air directly.

・ Not near the television Antenna or antenna cable.

・ Not higher than altitude of about 2000 meters above sea level.

・ Not in environment of precipitation or humidity(>95%)

Please AVOID direct sunlight, rain exposure, snow laying up during installation and

operation. Before connecting all wires,please take off the metal cover by removing

screws as shown below:

Considering the following points before selecting where to install:

・ Please select a vertical wall with load-bearing capacity for installation, suitable for

installation on concrete or other non-flammable surfaces,installation is shown below.

・ Install this inverter at eye level in order to allow the LCD display to be read at all times.

2(US)/1(EU)

- 05 -

・ The ambient temperature should be between -25~60℃ to ensure optimal operation.

・ Be sure to keep other objects and surfaces as shown in the diagram to guarantee

sufficient heat dissipation and have enough space for removing wires.

≥500mm

For proper air circulation to dissipate heat, allow a clearance of approx. 50cm to the side

and approx.50cm above and below the unit.And 100cm to the front.

Mounting the inverter

Remember that this inverter is heavy!Please be careful when lifting out from the package.

Choose the recommend drill head(as shown in below pic) to drill 4 holes on the wall,

52-60mm deep.

1. Use a proper hammer to fit the expansion bolt into the holes.

2. Carry the inverter and holding it,make sure the hanger aim at the expansion bolt,fix the

inverter on the wall.

3. Fasten the screw head of the expansion bolt to finish the mounting.

- 06 -