Aqua Logic ALCUV-3 Installations- und Betriebsanleitung - Seite 7

Blättern Sie online oder laden Sie pdf Installations- und Betriebsanleitung für Laborausrüstung Aqua Logic ALCUV-3 herunter. Aqua Logic ALCUV-3 9 Seiten. Compact uv

Seite drucken
REMOVING ORGANICS FROM THE UV:
WARNING: Be sure to wear protective gear for your hands and eyes!!
•
Turn UV power switch off on control box.
•
Disconnect UV from plumbing and drain it.
•
Make a pure chlorine bleach solution (1 cup bleach to 1 quart
water)
•
Connect the flush kit hoses to the inlet and outlet of the UV sterilizer
or to the drain and flush kit inlet (if available).
•
Cycle the solution through the UV sterilizer for 5-10 minutes.
•
Drain the bleach solution from the UV sterilizer.
•
Rinse or flush the unit thoroughly to remove all chlorine. Continue to flush until you can no longer
smell chlorine. You may wish to add a few drops of a dechlorinator to insure that all chlorine has
been neutralized.
•
Reconnect the UV to the plumbing.
•
Replace UV sterilizer lid and install screws.
•
Turn pump on.
•
Apply power to UV sterilizer.
•
The view port should show a blue light after a few seconds.
REMOVING MINERAL DEPOSITS FROM THE UV:
WARNING:
Be sure to wear protective gloves and goggles!!
DO NOT COMBINE chlorine bleach with muriatic acid or equivalent. The resultant
gases may be poisonous.
•
Follow procedure as above except that you use muriatic acid or equivalent. Be sure to follow
product instructions carefully.
©2004 Aqua Logic,® Inc. 8268 Clairemont Mesa Blvd. Suite 302 San Diego, CA. 92111
Ph (858) 292- 4773 FAX (858) 279-0537 email: [email protected] website: www.aqualogicinc.com

Parts Listing:

All replacement parts are available directly from Aqua Logic, Inc.
Bulbs:
ALA-36 Watt Bulb
Ballast:
ALB-36 Watt Self-Starting Ballast
Quartz Sleeve:
ALQ-36 Watt Quartz Sleeve Assembly
Miscellaneous:
Bulb Pin Connector Assembly
Page 7