Aqua Medic Cubicus CF Qube Betriebshandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Aquarien Aqua Medic Cubicus CF Qube herunter. Aqua Medic Cubicus CF Qube 16 Seiten.

Overflow system

Fig. 2: Overflow system Cubicus CF Qube

Water inlet to the filter

Nut for

bushing

Slide ring for

bushing

Ball valve

Emergency overflow

Hose connection for re-circulation pump

Slide ring for

bushing

Nut for

bushing

Ventilation angle

10.

Adjustable joint for return line

Available spare parts: Please refer to www.aqua-medic.de.

In the Cubicus CF Qube, there is an overflow system behind the black panel to which the light is mounted. The

system consists of an overflow shaft with combs, a slotted pipe through which the water enters the filter, an

emergency overflow and a return line placed next to the overflow shaft. In the cabinet, there is a ball valve that

has to be slightly closed to control the water in the overflow box. If the valve is closed to heavily or the return

flow is blocked for some reason, the water rises in the aquarium and flows to the filter tank through the emergency

overflow. In such a case, the ball valve has to be opened a bit further and all blockages have to be eliminated. If

the overflow makes loud noises, the ball valve has to be closed a bit more so the water is bottled up stronger so

that no air is dragged along. At least in the initial phase this has to be controlled regularly and, if necessary, to

be adjusted.

With the supplied PVC tubes with moulded keys on one side for holding the nuts of the bushings (tank fittings),

these nuts can be tightened or released in the overflow box or aquarium. The bushings have to be installed

according to Fig. 2. Always re-tighten before use. The nut of the emergency overflow has to be screwed from the

bottom. The PVC tube key can be pushed out of the chamber of the filter tank from underneath over the tube of

the emergency overflow. The slide ring and nut have to be mounted manually beforehand and tightened as much

as possible. The rubber slide ring must always be attached to the side of the rotable nut, the rubber gasket on

the opposite side of the panel.

Fig. 3: Bushing or tank fitting (the glass pane is placed between slide ring 3 and rubber ring 2)