Dell PowerEdge M420 Anmerkungen zur Veröffentlichung - Seite 15

Blättern Sie online oder laden Sie pdf Anmerkungen zur Veröffentlichung für Server Dell PowerEdge M420 herunter. Dell PowerEdge M420 27 Seiten. Dell poweredge blade servers getting started guide
Auch für Dell PowerEdge M420: Information Update (38 seiten), Handbuch (25 seiten), Benutzerhandbuch (23 seiten), Wichtige Informationen Handbuch (35 seiten), Handbuch aktualisieren (32 seiten), Handbuch aktualisieren (28 seiten), Benutzerhandbuch (26 seiten), Benutzerhandbuch (22 seiten), Handbuch "Erste Schritte (12 seiten), Handbuch (38 seiten), Technisches Handbuch (46 seiten), Technisches Handbuch (48 seiten), Portfolio-Handbuch (27 seiten), Handbuch "Erste Schritte (14 seiten), Handbuch "Erste Schritte (12 seiten)

PowerConnect M6220/M6348/8024/8024F/M8024/M8024-k/

7024/7048/7024P/7048P/7024F/7048R/7048R-RA Release Notes

This capability adds support for responding to pings by the VRRP master, but does not allow the VRRP Master to

accept other types of packets. A configuration option controls whether the router responds to Echo Requests sent to a

VRRP IP address. When enabled, the VRRP master responds to both fragmented and un-fragmented ICMP Echo

Request packets. The VRRP master responds to Echo Requests sent to the virtual router's primary address or any of its

secondary addresses. When the VRRP master responds with an Echo Reply, the source IPv4 address is the VRRP

address and source MAC address is the virtual router's MAC address. The VRRP master does not respond to pings sent

from the master.

Members of the virtual router who are in backup state discard ping packets destined to VRRP addresses, just as they

discard any Ethernet frame sent to a VRRP MAC address.

Fragmentation and Reassembly:

Fragmentation and reassembly of VRRP packets is not supported.

 DHCP Relay

The following enhancements have been made to the operation of DHCP Relay to bring the implementation into

conformance with RFC 4649:

DHCPv6 Relay Circuit Id/Remote Id Types

RFC 4649 specifies the IANA assignment of the Relay Circuit Id sub-option and Remote Id option. The

implementation has been changed so that the administrator can no longer assign a numerical value to these TLVs as the

IANA assigned number is now used. The administrator can still enable or disable the insertion of these TLVs in

messages sent to the DHCP server.

Relay Information Option:

The operator has the ability to enable DHCP Relay Information Options both globally and on a physical interface. The

interface configuration overrides the global configuration for the selected interface.

Relay Information Option Check:

When DHCP Option-82 insertion is enabled for a relay agent, the server should echo received Option 82 unaltered back

toward the client. The relay agent is required to strip Option 82 information before relaying the BOOTPREPLY to the

DHCP client. When enabled, the Relay Information Option Check will cause the BOOTPREPLY packet to be dropped

if invalid sub-options are echoed by the DHCP server.

 L2 Address Table

The administrator can disable MAC address table aging.

The administrator can configure static forwarding of a MAC address on a specific VLAN.

NOTE:

By default, multicast frames are flooded by the switch. Utilize the

mac address-table multicast filtering command to disable flooding of

multicast frames.

System Firmware Version 4.1.0.6

Page 13