Dell Daily Deal E1909W Benutzerhandbuch - Seite 28

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Monitor Dell Daily Deal E1909W herunter. Dell Daily Deal E1909W 31 Seiten. Lcd monitor
Auch für Dell Daily Deal E1909W: Einrichten (2 seiten), Service-Handbuch (50 seiten)

Seite drucken

Back to Contents Page

Troubleshooting

Dell™ E1909W Flat Panel Monitor

Self-Test

Common Problems

Video Problems

Product Specific Problems

Dell Soundbar Problems

CAUTION:

Before you begin any of the procedures in this section, follow the

Self-Test

Your monitor provides a self-test feature that allows you to check whether your monitor is functioning properly. If your monitor and computer are properly

connected but the monitor screen remains dark, run the monitor self-test by performing the following steps:

1. Turn off both your computer and the monitor.

2. Unplug the video cable from the back of the computer. To ensure proper Self-Test operation, remove both Digital (white connector) and the Analog (blue

connector) cables from the back of computer.

3. Turn on the monitor.

The floating dialog box should appear on-screen (against a black background) if the monitor cannot sense a video signal and is working correctly.

While in self-test mode, the power LED remains green. Also, depending upon the selected input, one of the dialogs shown below will continuously

scroll through the screen.

4. This box also appears during normal system operation, if the video cable becomes disconnected or damaged.

5. Turn off your monitor and reconnect the video cable; then turn on both your computer and the monitor.

If your monitor screen remains blank after you use the previous procedure, check your video controller and computer, because your monitor is functioning

properly.

NOTE:

Self test feature check is not available for S-Video, Composite, and Component video modes.

Built-in Diagnostics

Your monitor has a built-in diagnostic tool that helps you determine if the screen abnormality you are experiencing is an inherent problem with your monitor, or

with your computer and video card.

NOTE:

You can run the built-in diagnostics only when the video cable is unplugged and the monitor is in self-test mode.

To run the built-in diagnostics:

1. Ensure that the screen is clean (no dust particles on the surface of the screen).

2. Unplug the video cable(s) from the back of the computer or monitor. The monitor then goes into the self-test mode.

3. Press and hold the

and

4. Carefully inspect the screen for abnormalities.

5. Press the

button on the front panel again. The color of the screen changes to red.

6. Inspect the display for any abnormalities.

7. Repeat steps 5 and 6 to inspect the display in green, blue, and white colored screens.

The test is complete when the white screen appears. To exit, press the

If you do not detect any screen abnormalities upon using the built-in diagnostic tool, the monitor is functioning properly. Check the video card and computer.

Common Problems

buttons on the front panel, simultaneously for 2 seconds. A gray screen appears.

Safety

Instructions.

button again.