Dell PowerEdge M915 Benutzerhandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Schalter Dell PowerEdge M915 herunter. Dell PowerEdge M915 23 Seiten. Dell poweredge blade servers getting started guide
Auch für Dell PowerEdge M915: Anmerkungen zur Veröffentlichung (27 seiten), Handbuch (25 seiten), Wichtige Informationen Handbuch (35 seiten), Handbuch "Erste Schritte (12 seiten), Handbuch "Erste Schritte (12 seiten), Benutzerhandbuch (3 seiten), Portfolio-Handbuch (27 seiten), Handbuch "Erste Schritte (14 seiten), Handbuch "Erste Schritte (12 seiten)

Dell -10GbE PTM

The PTM supports hot-insertion into the chassis. If the PTM is inserted to a powered chassis, the

power LED (green) should turn on immediately.

2.2.2 PTM Removal

The PTM supports hot-removal. It may be removed when the chassis is powered on or off.

The PTM must not be removed during a firmware update process.

Note: Firmware update is in progress when the Yellow LED is blinking.

2.3

The PTM front panel presents 16 SFP+ ports. Each port provides connectivity to a server with the

respective number. Figure 4 shows the front panel view of the PTM.

Figure 4: Dell 10Gb Ethernet Pass Through -k module Front Panel

10 Gb Ethernet Pass Through -k

The PTM supports SFP+ modules for 10 Gigabit Ethernet, with 10GBASE-SR and 10GBASE-LR

PHYs. SFP+ modules must be approved for use with this PTM. Modules not approved may not

work. See Supported Cables and Media Types on page 19 for lists of approved Direct Attached

Copper cables (DACs) and optical modules.

Optical transceiver modules have a locking mechanism which can be opened or closed.

To insert the module into the cage:

1. Open the module's locking mechanism.

2. Make sure that the male connectors on the module aligns with the female connector inside of

the cage. Also check that there is no dirt or foreign matter in the module or in the cage.

3. Insert the module into the adapter card module cage.

4. Close the locking Mechanism.

To remove the module from the cage:

1. Unlock the locking mechanism by opening the handle.

2. Pull the module out of the cage.

Rev 1.0