Miele DA 6290 D Betriebs- und Installationsanleitung - Seite 21

Blättern Sie online oder laden Sie pdf Betriebs- und Installationsanleitung für Lüftungshaube Miele DA 6290 D herunter. Miele DA 6290 D 36 Seiten.
Auch für Miele DA 6290 D: Betriebs- und Installationsanleitung (32 seiten)

Miele DA 6290 D Betriebs- und Installationsanleitung
Cleaning the grease filters by hand
^ Clean the filters with a soft nylon
brush in a mild solution of hot water
and a little washing-up liquid.
Do not use "neat" washing up liquid.
Do not use:
– cleaning agents containing
descaling agents,
– powder cleaners, cream cleaners or
abrasive all-purpose cleaners.
– oven sprays.
Cleaning the grease filters in the
dishwasher
^ Place the filters as upright as
possible in the lower basket, with the
short sides upright. Make sure that
the spray arm can move freely.
^ Do not wash at more than 65° C. If a
Miele dishwasher is being used,
select the Sensor wash programme.
^ Use a mild dishwasher detergent.
Depending on the cleaning agent
used, cleaning the filters in a
dishwasher can cause permanent
discolouration to the surface.
However, this will not affect the
functioning of the filters in any way.
^ After cleaning, leave the filters to dry
on an absorbent surface before
replacing them.
Cleaning and care
^ When removing the filters for
cleaning, also clean off any residues
of oil or fat from the now accessible
housing to prevent the risk of these
catching fire.
^ Replace the grease filters, making
sure that the locking clips are facing
down towards the hob.
^ If a grease filter is inadvertently
replaced upside down, insert a small
screwdriver blade into the slit to
disengage the clip.
Resetting the Grease filter operating
hours counter
After cleaning, the operating hours
counter needs to be reset.
^ Whilst the fan is switched on, press
the Operating hours control l— for
approx. 3 seconds until only the 1 is
flashing.
The Grease filter symbol l— goes
out.
If you want to clean the grease filters
before the operating hours counter has
reached its maximum,
Press the Operating hours control l—
for approx. 6 seconds until only the 1 is
flashing.
21